2. Axiom
  3. FI-0169-00

Axiom FI-0169-00 User manual

  • Hello! I've reviewed the assembly instructions for the Axiom AX16CL/AX8CL pole adapter and KPTFAX16CL floor stand. This document details the steps for assembling the adapter, attaching it to the floor stand, and using it to support AX16CL or AX8CL speakers. It specifies maximum load for speaker configuration and proper setup for stability. Feel free to ask me any questions about the installation process or the product's features.
  • What is the maximum number of speakers that can be installed on the pole adapter?
    What should be the aiming of the column?
    What is required to properly set the KPTFAX16CL?
AX16CL/AX8CL POLE ADAPTER
CODE: KPTPOLEAX16CL
Assembly Instruc�ons
SUPPLIED MATERIALS
Manufactured by PROEL
ITALY
FI-0169-00
This drawing is the exclusive property
of PROEL S.p.A. and cannot be
reproduced without prior authoriza�on.
CONDITIONS OF USE
Proel do not accept any liability for damage caused to third par�es due to improper installa�on, use of non-original spare parts, lack of maintenance,
tampering or improper use of this product, including disregard of acceptable and applicable safety standards. Proel strongly recommends that this
loudspeaker cabinet be suspended taking into considera�on all current Na�onal, Federal, State and Local regula�ons. The product must be installed
by qualified personnel only. Please contact the manufacturer for further informa�on.
ASSEMBLY SEQUENCE
PROEL S.p.A. - Via alla Ruenia 37/43 - 64027 Sant'Omero (Te) - ITALY Tel: +39 0861 81241 www.axiomproaudio.com
OPTIONAL MATERIALS
DHSS10M20 KP210S
KPTFAX16CL
M6 KNOB
LOCKING PIN
(94SPI10555)
M6 KNOB
M6 FLAT
HEAD SCREW
POLE ADAPTER
COLUMN
SPEAKER
ADAPTER
1 - Remove the Pin (B).
2 - Unscrew the 4 screws (C).
3 - Remove the flange (A)
from base.
4 - Screw in the pole
(D).
5 - Insert the pole
adapter (E).
6 - Loosen the knobs (F)
and (G).
7 - Place the column (H).
8 - Insert the front pin (I).
9 - Insert the rear pin (L).
10 - Tighten the knobs (F)
and (G).
WARNING:
• The ground where the KPTFAX16CL floor stand is placed needs to be stable and compact.
• Adjust the feet so to put the KTPFAX16CL perfectly horizontal. Use a spirit level to obtain the best result.
• Always secure ground stacked setups against movement and possible �pping over.
• A maximum of 1 x AX16CL or 2 x AX8CL speakers are allowed to be installed over a KPTFAX16CL
with pole serving as ground support.
• The column must be setup with 0° aiming.
/