Quick Setup Guide l NS-IPSD2 MP3 Speaker with Dock for iPod
Congratulations on your purchase of a high-quality Insignia
product. Your NS-IPSD2 represents the state of the art in
MP3 speaker system design and is designed for reliable and
trouble-free performance.
Package contents
• MP3 speaker system
• AC power adapter
• 8 iPod adapters
• Soft carrying pouch
Features
• Certied iPod connector installed for iPod dock
• Recharge circuit for iPod/mini/nano/ photo/video/touch
• Includes docking brackets to t iPod players
• Controls a connected iPod
• Digital volume control
• 3.5 mm type Aux-In jack for shue and other
audio players
• Battery backup (4 x AA not included)
Front with dock open
1 Volume control
buttons
Press to adjust the
volume.
2 Power button Press to turn your speaker
system on or o. When
your speaker system is
turned on, the LED lights.
Back
Installing the batteries
1 Remove the battery compartment cover.
2 Insert four AA batteries into the battery
compartment. Make sure that the ( +) and ( – )
symbols on the batteries align with the (+) and ( – )
symbols inside the battery compartment.
3 Replace the cover.
Connecting the AC power adapter
• Connect the AC power adapter to the DC IN jack on
the back of your speaker system and to an electric
outlet.
Inserting an iPod
1 Make sure that batteries are installed in the speaker
system or the AC power adapter is connected to the
speaker system.
2 Press the open dock button on the front of your
speaker system to unfold the dock.
3 Select the correct adapter, then insert it into the
iPod dock.
4 Insert the iPod into the adapter.
5 Pull the stand out to set the speaker system upright.
6 Press the power button. The LED lights.
7 Press volume up or down to adjust .
8 Press the power button again to turn o your
speaker system.
For more information about using your speaker system,
including connecting it to a stereo system, see your User Guide.
FCC Part 15
This device complies with Part 15 of the FCC Rules. Operation
of this product is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received,
including interference that may cause undesired operation.
This equipment has been tested and found to comply
within the limits for a class B digital device, pursuant to Part
15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates, uses, and
can radiate radio frequency energy and, if not installed and
used inaccordance with the instructions, may cause harmful
interference to radio communications. However, there is
no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by
turning the equipment o and on, the user is encouraged to
try to correct the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment
and receiver.
• Connect the equipment into an outlet on a circuit
dierent from that to which the receiver is connected.
• Consult the dealer or an experienced technician for help.
FCC warning
Changes or modications not expressly approved by the
party responsible for compliance with the FCC Rules could
void the user’s authority to operate this equipment.
Canada ICES-003 statement
This Class B digital apparatus complies with Canadian ICES-003.
One-year limited warranty
See the online User Guide or visit
www.insigniaproducts.com for details.
© 2009 BBY Solutions, Inc.
All rights reserved. INSIGNIA is a trademark of
BBY Solutions, Inc. Registered in some
countries. All other products and brand names are
trademarks of their respective owners.
ENGLISH 09-1062
1 Open dock button Press to open the dock.
2 Speakers Produce sound.
3 Dock Unfold the dock to insert
the iPod and adapter.
1 Battery
compartment
Insert batteries into this
compartment
2 DC IN Connect the AC power
adapter to this jack and to
a power outlet.
3 AUX IN Connect an audio device
via 3.5 mm audio cable
(not included)
4 Stand Unfold the stand to set
your speaker system in an
upright position.
2
3
1
2
3
1 2
3
4
1 2
2
/