INSTRUCTIONS MANUAL
MODEL: UBF-655
12” Box Fan
Thank you for your purchasing this fan. Please read all instructions carefully and
keep for future use.
Please read these Operating Instructions through carefully before connecting your
device to the mains, in order to avoid damage due to incorrect use. Please pay
particular attention to the safety information. If you pass the device on to a third party,
these Operating Instructions must also be handed over.
How to operate the fan
IMPORTANT:
REMOTE CONTROL
The Remote Control requires 2 AAA batteries (not supplied) for operation.
To install the batteries, simply depress the back of the remote, with your thumb in the indentations,
and remove the cover. Insert the batteries according to the diagram shown inside. Replace the cover.
Operating
1. Set the fan on a dry level surface.
2. Plug the cord into a suitable 220-240V AC outlet.
3. Turn the fan on by pressing the Speed button – I II III – on the remote control or on the control
panel. (see fig. 1/2). The appropriate LED light on the front of the fan will illuminate. Turn the fan
Off by pressing the OFF button. Pressing the OFF button will automatically clear all settings and
reset the fan.
4. The speed is adjusted by repeatedly pressing the Speed button – I II III – on the remote control
or on the control panel.
I = Low speed II = Medium speed III = High speed
The appropriate LED light on the front of the fan will illuminate.
ADJUSTMENT
Oscillation control (see fig. 1/2)
To start and stop oscillation of the wind wheel, push the Oscillation button on the remote
control or on the control panel.
Timer control (see fig. 1/2)
To start and stop the timer, press the Timer button on the remote control or control panel to
cycle through the timer settings.
The appropriate LED light on the front of the fan will illuminate.
Natural breeze movement / Sleep control (see fig. 1/2)
1. For a natural breeze movement, push the Breeze button once. This will automatically vary
the fan speeds faster and slower.
2. Push the button again to activate the sleep control. This function slows the fan speed
down and when used in conjunction with the timer settings will gradually slow the fan down and
switch off. e.g. SLEEP + 4hrs TIMER programs the fan to gradually slow down over the 4 hours and
eventually turn off.
3. Push the button a 3d time to switch off the BREEZE and SLEEP functions.
The appropriate LED light on the front of the fan will illuminate when the Breeze function is selected.
Fig 2
Fig1 Fig 1
CAUTION
♦ Do not use this appliance near water.
♦ Do not use this appliance near bathtubs, showers, basins or other vessels containing water.
♦ Never immerse the motor unit, cord and plug into water
♦ If the appliance fell down into water, unplug it immediately, then take it out and bring it to
authorized Service Center for checking
♦ Never use the appliance with wet hands
♦ Never use the appliance on a damp floor
♦ Never use the appliance with an extension lead
♦ Never use the appliance with the damaged wall outlet
♦ Any examination, repair or adjustment must be done in an authorized Service Center.
♦ Do not repair the appliance by yourself! If the opening of the appliance is detected, the
appliance's guarantee will be canceled.
♦ Never use the appliance near or on the hot surfaces
♦ Never let the cord hang over the edge of the table or touch any hot surfaces
♦ Always unplug the appliance when not in use/before cleaning
♦ Do not let children play or use the appliance
♦ Give a high attention when the appliance is being used near the children
♦ Use the appliance only for it’s direct purpose
♦ Never expose the appliance to fall down or to be kicked
♦ While using the appliance, please, observe the safety precautions
♦ Use the appliance in a well ventilated area. While in use, ensure that the air-intakes or exhaust
openings are not blocked un-expectedly and the appliance distance from the wall or corner is
more than 20 cm. The appliance should not be placed below or besides any curtains or similar
♦ Incorrect operation and improper handing can lead to malfunctions of the appliance and injuries
to the user
♦ To avoid mechanical danger when in use, do not insert, or allow fingers, or any other objects into
the grill. Do not block the air-intakes or the exhaust openings in any manner.
♦ If the appliance has been used with infringement of guide’s instructions, the appliance’s
guarantee would be canceled and consumer would repair the appliance at his/her expense
♦ This appliance is not intended for use by person (including children) with reduced physical,
sensory or mental capabilities, or lack of experience and knowledge, unless they have been given
supervision or instruction concerning use of appliance by a person responsible for their safety.
CARE AND CLEANING
To safely take care of your fan, please remember to follow these instructions below:
♦ Always remove the plug from the socket-outlet, and allow the fan to stop completely before
cleaning the fan
♦ Do not allow water to drip on, or enter into the fan housing
♦ Always use a soft wet cloth to clean the body, and vacuum cleaner to clean the dust from the
blades
♦ Do not use any of the following agents as a cleaner: Gasoline, Thinners, or Benzene
♦ In case of malfunction or doubt, do not try to repair the fan yourself, it may result in a fire
hazard or electric shock
♦ Clean the fan grill, housing and base with a soft damp cloth.
♦ Do not attempt to remove the fan blades. Please use caution around the motor housing area.
♦ Do not allow the motor, or other electrical components to be exposed to water.
♦ When storing your fan in the off-season, it is important to keep it in a safe dry location. It is
important to protect the fan head from any dust. We strongly recommend using the original box,
when storing the fan away.
NOTICE ABOUT RECYCLING
Your product is designed and manufactured with high quality materials and components which
can be recycled and reused.
This symbol means that electrical and electronic equipment, at their end-of-life,
should be disposed of separately from your household waste. Please dispose of this equipment at
your local community waste collection/ recycling centre.
In the European Union there are separate collection systems for used electrical and electronic
products.
Please help us to conserve the environment we live in!
DECLARATION OF CONFORMITY
This product complies with the requirements of Directives:
EMC Directive: 2004/108/EC
Low Voltage Directive: 2006/95/EEC
Rohs2 Directive: 2011/65/EU
The above directives declare that this model is in compliance
with following norms:
EN 55014-1:06+A1:09+A2:11
EN 55014-2:97+A1:01+A2:08
EN 61000-3-2:06+A1:09+A2:09
EN 61000-3-3:13
EN 60335-2-80:03+A1:04+A2:09
EN 60335-1:12
EN 62233:08
Commission Regulation (EU) No. 206/2012
IEC 60879-1986
EN 50564:11, EN 60704-2-7:98, EN 60704-1:10+A11:12
IEC 62321-3-1:13, IEC 62321-4:13, IEC 62321-4:13
EN 62321:09
ISO 17075:07
Accurate Technology Co.,Ltd. – RoHS assessment
EXCLUSIVE DISTRIBUTOR IN GREECE
Amiridis-Savvidis S.A.
87A, 17th November Str., P.C. 55535
Pylaia - Thessaloniki - Greece
Τ: +302310944944 | F: +302310944940
www.amiridis-savvidis.gr
/
