Brodit 854993 Datasheet

Category
Holders
Type
Datasheet
29 January, 2015, www.brodit.com, © 2015 Brodit AB
Product 854993
854993 ProClip
Center mount
The ProClip is a mounting bracket for the vehicle’s dashboard. Onto the ProClip you can install e.g. a holder for
your mobile phone or PDA or a handsfree set etc. Safe and convenient - always within easy reach. The ProClip is
car specific and easy to install. The installation is quick, no special tools or dismantle of the dashboard is required
and it will not damage the interior of the vehicle. Made in black ABS plastic. Comes with detailed instructions.
EAN: 7320288549934
Item no 854993 fits:
Nissan Qashqai 14-15 (For all countries)
Nissan Rogue 14-15 (For USA)
Nissan X-Trail 14-15 (For all countries)
1(2)
1. 2.
INSTALLATION INSTRUCTIONS
4.3.
Please read the instructions and look at the pictures before installing the ProClip.
1. Use the enclosed alcohol pad to clean the area where the ProClip is to be installed. Press the thin end of the
enclosed gap opener into the gap between the frame surrounding the air vent panel and the dashboard
overhang, to widen the gap. Remove the adhesive tape cover on the ProClip.
2. Press the lower edge of the ProClip into the gap dividing the center console. Press the lower edge all the way
in to the gap at the same time as you press the upper part of the ProClip upward/forward.
3. Hook the angled upper edge of the ProClip into the gap next to the gap opener. Remove the gap opener.
4. The ProClip is in place.
2(2)
  • Page 1 1
  • Page 2 2

Brodit 854993 Datasheet

Category
Holders
Type
Datasheet

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI