Legrand Plugmold Plug-in Units User manual

Type
User manual
PLUGMOLD
®
PLUG-IN UNITS
I N S T A L L A T I O N I N S T R U C T I O N S
WARNING: For maximum safety, Plugmold Plug-In Units are
equipped with a grounding type plug (3-prong) for use
only with grounding type receptacles. Modification of
the plug to allow its use in non-grounding receptacles
voids the warranty and may lead to electrical shock.
1. Determine the installation location and rotate the
Plugmold Plug-In Unit to the necessary orientation
as follows:
a. Loosen the 2 phillips head screws near the plug
blades. Do not fully remove the screws.
b. Pull the rotating section of the plug outwards and
rotate to the desired orientation. The Plugmold
Plug-In Unit will rotate in 90° increments only.
c. Push in the rotating section of the plug and tighten
the 2 phillips head screws.
2. Plug the Plugmold Plug-In Unit into the desired
receptacle, hold securely, and mark the wall on top
and bottom of the Plugmold Plug-In Unit where the
mounting clips will be installed.
INSTALLATION:
Legrand/Wiremold electrical systems conform to and should be
properly grounded in compliance with requirements of the current
National Electrical Code or codes administered by local authorities.
All electrical products may present a possible shock or fire hazard if
improperly installed or used. Legrand/Wiremold electrical products
may bear the mark of a Nationally Recognized Testing Laboratory
(NRTL) and should be installed in conformance with current local
and/or the National Electrical Code.
1 010 518 0811
© Copyright 2011 Legrand/Wiremold All Rights Reserved
WIREMOLD
U.S. and International:
60 Woodlawn Street • West Hartford, CT 06110
1-800-621-0049 • FAX 860-232-2062 Outside U.S.: 860-233-6251
Canada:
570 Applewood Crescent • Vaughan, Ontario L4K 4B4
1-800-723-5175 • FAX 905-738-9721
3. Unplug the Plugmold Plug-In Unit and install the
mounting clips on the wall. IMPORTANT if the flat
head screws furnished are not used, the substitute
fasteners must also be of the flat head type, or the
unit will not seat securely in the mounting clips.
4. Plug the Plugmold Plug-In Unit into the receptacle
and snap into the mounting clips.
INSTALLATION (continued):
  • Page 1 1
  • Page 2 2

Legrand Plugmold Plug-in Units User manual

Type
User manual

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI