Lithonia Lighting FMML 13 830 Installation guide

Type
Installation guide
Luminaire Variant
FMML (dry/damp location) Cat. No. FMML 13 840
FMML with WL option (wet location) Cat. No. FMML 13 840 WL
These installation instructions are used for installing the following luminaires and kits
Identification of the flush mount luminaire and parts…..………………………………… Page 1
Installation of the gasket (wet location version only) .…………………………...………..Page 2
Installation of the luminaire ……………………...…….…………………....…………..…. Page 2
A) Identification of the Luminaire
Versi Lite LED Flush Mount
INSTALLATION INSTRUCTIONS
U990103 Rev. B
Page 1
© Acuity Brands Lighting, Inc. 2015
All Rights Reserved.
Metal fixture
body
Acrylic twist
off diffuser
Hardware
bag parts
If assistance is required, contact technical
support at (800) 748-5070
Suggested Dimmers
This fixture is designed to operate with most standard Triac Based (Forward Phase-Control or Leading Edge) dimmers and
is not compatible with 0-10v dimming systems. Noted below is a listed of dimmers that have been tested with this fixture.
This list of dimmers does not imply any guarantee or warranty of compatibility with a particular application. Dimmers that
are not listed do not imply non-compatibility.
Lutron: DVELV 300P, Skylark 300P, NTELV 300, NLV 600
Leviton: 6633P, IPL06, 6674P, IPE04,6683
Synergy: ISD 600I 120
Pass & Seymour HCL453PTCCCV6
U990103
Rev. A 04/02/2015
B) Installation of the gasket (wet location version only)
C) Installation
1
Required tools
2
Fixture parts list
Gasket
Luminaire
Peel away the liner and stick
gasket to the surface,
ensuring that the holes in
both are lined up
U990103 Rev. B
Page 2
© Acuity Brands Lighting, Inc. 2015
All Rights Reserved.
C) Installation Continued
U990103
Rev. A 04/02/2015
3
Remove the mounting parts from the pre-pack bag. Ensure
that no parts are missing.
U990103 Rev. B
Page 3
© Acuity Brands Lighting, Inc. 2015
All Rights Reserved.
4
Remove the diffuser lens (A) by twisting counterclockwise. The
diffuser is retained with friction snap features. No fasteners
are required to install it. You will now see the center hole thru
the fixture (B). Do not remove any other parts.
NOTE: Turn off power at fuse or circuit breaker box!
5
Screw the gem bar (C) to your junction box with the provided
screws. The gem bar should be flush with the ceiling when
correctly mounted. Some variation is acceptable.
6
Screw the threaded stem (D) thru the gem bar and thread a
hex jam nut (E) on either end of the threaded stem. Tighten
the jam nuts until the threaded stem is secure. You will have to
experiment with the length of exposed stem depending on
your ceiling thickness. You only need 5 threads sticking thru
the barrier lens to secure it.
7
Wet location version:
Peel the paper liner from the gasket and
apply the gasket to the back of the luminaire
ensuring that the holes in both line up.
If you have the dry/damp location version, skip to step 8
8
Connect the green ground wire from the
fixture to the bare copper ground wire from
the junction box using a wirenut (F). (If house
wiring does not include a ground wire,
consult your local electrical code for
approved grounding methods).
Finish the wiring by connecting the black
fixture wire to the black power supply wire
and the white (neutral) fixture wire to the
white power supply wire.
9
Align the threaded stem with the hole in the middle of the
fixture. Put the threaded stem through the hole, and start the
½”nut (G). Tighten the ½”nut with the appropriate tool until it
can no longer move and the fixture is secure.
10
Lift Diffuser up to housing assembly aligning slots on
diffuser with tabs on barrier lens.
Twist diffuser clockwise until secure.
11
Turn on electricity at fuse or circuit breaker box.
WARNING: RISK OF SHOCK- Do not operate
fixture without Barrier Lens (8) installed.
B
A
D
E
C
F
G
Clean surfaces with mild soap and water. Do not
use abrasive materials such as scouring pads or
powders.
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6
  • Page 7 7
  • Page 8 8
  • Page 9 9
  • Page 10 10
  • Page 11 11
  • Page 12 12

Lithonia Lighting FMML 13 830 Installation guide

Type
Installation guide

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI