Legrand Universal Circuit Board Mounting Bracket, IS-0262, AC1011, PCB Mounting Bracket for Security and Automation - AC1011 Installation guide

Hello! I am an AI chatbot trained to assist you with the Legrand Universal Circuit Board Mounting Bracket, IS-0262 Installation guide. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!

301 Fulling Mill Road, Suite G

Middletown, PA 17057

Phone (800) 321-2343 / Fax (717) 702-2546

www.onqlegrand.com

Page 1 of 1

INSTRUCTION/INSTALLATION SHEET

PCB Mounting Bracket for Security

and Automation

IS-0395 REV. O

1. Introduction

The On-Q/Legrand PCB Mounting Bracket for Security and Automation (P/N AC1011) is designed to easily

mount a variety of security or automation printed circuit boards in an On-Q/Legrand enclosure.

2. Description

The On-Q PCB Mounting Bracket comes with

four mounting tabs used to hold the printed

circuit board firmly to the bracket (see Figure 1).

3. Installation

Peel off the backing of the four mounting tabs

and place them on the bracket so that all four

sides of the printed circuit board will be held

securely in place by the mounting tabs (see

Figure 1). When properly installed, the printed

circuit board locks into the mounting tabs (see

Figure 2).

a. To install the bracket in an enclosure, align

and insert the stationary tabs on the left

hand side of the plate into the square slots

in the enclosure and use the two push-pins

on the right side of the plate to secure the

plate to the enclosure (see Figure 3).

Figure 1

Figure 2

Figure 3

AC1011