Castle Creations CSE010010400 User guide

CSE010010400
Brand
Castle Creations
Model
CSE010010400
Type
User guide

This manual is also suitable for

EDGE ESC LOCK HARNESS AND KEY
Mounting
The socket may be
installed through a
panel or secured inside a
fuselage.
Wiring Diagram
Connect the white wire to the Aux Line (white wire) on
an Edge ESC.
Connect the red “+” wire to any servo wire with a Y
harness.
Warning
Edge Arm Lock mode is intended as a
secondary safety device. It is not intended
to replace safe practices or careful handling
of your RC power system, vehicle, and
transmitter.
Edge Arm Lock is only operational if you
have successfully configured the Edge ESC
using Castle Link software.
Edge Arm Lock requires that the AUX LINE
of the Edge ESC receives a voltage between
1.8V and 8.4V to arm. Failure of the power
source (0 volts) will cause the ESC to enter
Arm Lock mode.
Operation
Key in socket OR disconnected wire in socket harness
= ARM LOCKED.
A properly programmed and wired Edge will be
incapable of arming when the key is in the socket.
If the key is placed in the socket or the arm lock socket
loses power, the ESC will go into a locked state - even
if it is running.
Key removed + power to socket = ARM UNLOCKED. ESC
must receive low throttle signal to arm and run.
ARM LOCK
SOCKET AND KEY
™
™
Before completing any of the
following steps, make sure
that the Edge ESC’s Aux line
mode is set to “Arm Lock
Key”. This setting can be
found on the “OTHER” tab in
the Castle Link software.
© 2013 Castle Creations, Inc. P/N: 095-0230-00 Revision Date - 03/2013
  • Page 1 1
  • Page 2 2

Castle Creations CSE010010400 User guide

CSE010010400
Brand
Castle Creations
Model
CSE010010400
Type
User guide
This manual is also suitable for
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Other documents