TT2A-UTK-SHROUD
Under-Table Utility Shroud
Installation Guide
Installation
Use the following procedure to install the
TT2A-UTK-SHROUD onto a cable caddy.
1. Identify the four outermost circular cutouts on the
installed cable caddy support bracket ange.
Refer to the following image for the cutout
locations.
Cable Caddy Support Bracket (One Cutout Hidden)
Description
The Crestron
®
TT2A-UTK-SHROUD utility wrap
attaches to the TT2-100 Crestron Connect It™ Cable
Caddy underneath a table, keeping all cables neatly
hidden.
Overview
The TT2A-UTK-SHROUD is a rectangular piece of
sturdy yet exible woven polyester material with interior
(shiny) and exterior (matte) sides. Along one edge, four
metal clips are secured to the material with grommets.
Two strips of hook and loop fabric fasteners are sewn
along the length of each adjacent side. The
TT2-UTK-SHROUD forms a cylinder when the two
fasteners are secured together.
Rolled TT2A-UTK-SHROUD with Edge Fastened
Additional Resources
Visit the product page on the
Crestron website (www.crestron.com)
for additional information and the
latest rmware updates. Use a QR
reader application on your mobile
device to scan the QR image.
2. Attach the four metal clips on the
TT2A-UTK-SHROUD to the four circular cutouts
with the opening facing the user and the matte
side facing out.
TT2A-UTK-SHROUD Installation
Cutout
Cutout
Cutout
This
side
faces
user
Ø9.00 in
(229 mm)
25.38 in
(645 mm)
1.25 in
(32 mm)
Metal clips (4x)
Shroud fabric
3. Conrm that all cables are surrounded by the
shroud before joining the two strips of hook and
loop fabric fasteners at the opening.
Shroud opening
facing user
Exterior side
(matte)
Interior side
(shiny)
Metal clips (4x)
Cutout (4x)
Product warranty can be found at
www.crestron.com/warranty.
The specic patents that cover Crestron products are listed at
www.crestron.com/legal/patents.
Certain Crestron products contain open source software. For
specic information, please visit
www.crestron.com/opensource.
Crestron, the Crestron logo, and Crestron Connect It are
either trademarks or registered trademarks of Crestron
Electronics, Inc. in the United States and/or other countries.
Other trademarks, registered trademarks, and trade names
may be used in this document to refer to either the entities
claiming the marks and names or their products. Crestron
disclaims any proprietary interest in the marks and names of
others. Crestron is not responsible for errors in typography or
photography.
This document was written by the Technical Publications
department at Crestron.
©2018 Crestron Electronics, Inc.
Crestron Electronics, Inc. Installation Guide
15 Volvo Drive DOC. 8222B
Rockleigh, NJ 07647 (2049459)
Tel: 888.CRESTRON 07.18
Fax: 201.767.7576 Specications subject to
www.crestron.com change without notice.
/