2. Riverside
  3. Myra 59347

Riverside Myra 59347, 59347, 59397 Assembly Instructions

  • I've reviewed the assembly instructions for the Myra #59397 dining room chair. This document provides a clear, step-by-step guide on how to assemble the chair, explaining the usage of each included component such as bolts, washers, and the Allen wrench. I am ready to answer your questions about the assembly process.
  • What components are included in the assembly?
    What is the first step of assembly?
    What tool is used for tightening bolts?
    What is the correct order of assembly?
#59397
Xx Back Side Chair
Riverside
Components and Hardware List
email: [email protected]
FURNITURE
Made in Viet Nam
Page 1 of 2
Back Assembly
A
Myra
Dining Room
Assembly Instructions
1 pc. B
Chair Seat
1 pc.
Be sure to check all packing material carefully
for small parts, which may have come loose
inside the carton during shipment.
D
Front Leg
2 pcs.
I
EF
5mm Allen
Wrench
5/16" Spring
Washer
G
4 pcs. 9 pcs. 9 pcs.
5 pcs. H
1 pc.
Steps:
1. Place the Back Assembly (A) on a soft and smooth surface.
2. Attach Chair Seat (B) to the Back Assembly (A) by using the 3" long Bolt (F)
Spring Washer (G) and Flat Washer (H) into the back corners of the Seat and 2"
long Bolt (E) Spring Washer (G) and Flat Washer (H) into the middle of the Seat,
as shown in (Detail A). Do not fully tighten Bolts until after next step.
M5/16"-18 x 3"
Long Allen Head
Bolt
5/16" *19*2mm
Flat Washer
M5/16"-18 x 2"
Long Allen Head
Bolt
Detail A
A
B
F
I
HG
IEGH
Riverside
email: [email protected]
FURNITURE
Made in Viet Nam
Page 2 of 2
Myra
Dining Room
Assembly Instructions
Detail B
3. Attach Front Legs (D) to the Chair Seat (B) by using the 2" long Bolts (E)
Spring Washer (G) and Flat Washer (H) as shown in (Detail B).
4. Turn the Chair upright on a flat surface to level chair and tighten all Bolts
using the Allen Wrench (I).
I
E
G
H
D
/