2. Rapid Racking
  3. Modular mobile benches

Rapid Racking Modular mobile benches Assembly Manual

  • I have reviewed the assembly instructions for the RapidRacking Mobile Bench NMMB1 . The document provides detailed steps on how to assemble the modular mobile bench, including fitting castors, beams, and shelves. I'm ready to answer any questions you have about the assembly process or the features discussed in the document.
  • What tools are required for assembly?
    What safety precautions should I take during assembly?
    What should I do with the shelves?
Modular mobile benches
Assembly instruction
AIW016
AIW016
MODULAR MOBILE BENCHES & TOOL STATIONS Multiple Packages
IMPORTANT - ASSEMBLY INSTRUCTIONS
For Mobile Bench NMMB1
1Fit castors Eto uprights Ausing screws F.
2Assemble both ends first - Aand Bstarting
from the bottom, allow 1 clear hole for the
first side beam B. Fit the top side beams to the
top holes of the uprights.
3Tap together using rubber mallet.
4Fit front and rear beams Cto uprights Alevel
with side beams B.
5Position shelves D into place.
ASSEMBLY
We advise the use of
protective gloves and
goggles, or eyeglasses
when assembling
this product.
Tools required:
Rubber mallet
A
A
D
D
B
B
C
C
E
F
Illustration shows
Mobile Bench NMMB1
Castor must
fix through
hole nearest
the upright.
Uprights
COMPONENTS
IMPORTANT - ASSEMBLY INSTRUCTIONS
AIW016
A
Keep heavier items
on the bottom shelves
Do not climb
on your shelving
Make sure it is on a
level and even floor
Keep your
shelving dry
BSide beams
610 mm
4 of per bay
SAFETY
915 mm or 1600 mm
4 of per bay
CFront and rear beams
915 mm or 1525mm
4 of per bay
DMDF shelves
2 of per bay
ECastor pack
4 of per bay
FScrews and bolts
1 set per castor
MODULAR MOBILE BENCHES & TOOL STATIONS Multiple Packages
/