Black Box RM3010A User manual

Order toll-free in the U.S.: Call 877-877-BBOX (outside U.S. call 724-746-5500)

FREE technical support 24 hours a day, 7 days a week: Call 724-746-5500 or fax 724-746-0746

Mailing address: Black Box Corporation, 1000 Park Drive, Lawrence, PA 15055-1018

Web site: www.blackbox.com • E-mail: [email protected]

CUSTOMER

SUPPORT

INFORMATION

SEPTEMBER 2003

RM399

RM403

RM410

RM589

Fixed, Vented Server Shelves for

Elite Series Data Cabinets

This installation sheet covers four models of Fixed, Vented Server Shelves for use with the Elite Series Data

Cabinets:

• The RM399, RM403, and RM410 are the proper width for mounting in a cabinet assembled with 19"

(48.3-cm) rack rails. The RM399 supports equipment weighing up to 200 lb. (90.7 kg) and is 22.25"

(56.5 cm) deep. The RM403 and RM410 both support equipment weighing up to 150 lb. (68 kg); the RM403

is 27.25" (69.2 cm) deep and the RM410 is 30" (76.2 cm) deep.

• The RM589 is the proper width for mounting in a cabinet assembled with 23" (58.4-cm) rack rails. It

supports equipment weighing up to 200 lb. (90.7 kg) and is 22.25" (56.5 cm) deep.

Each of these shelves has four “mounting ears”: two at the front and two at the back. To mount one of them in

the cabinet, first tilt the shelf far enough sideways to get past the cabinet’s rails, then maneuver it through the

cabinet until its front and rear mounting ears are even with the cabinet’s front and rear rails. Straighten the shelf

back to level so that its front ears are flush against the front of the cabinet’s front rails and its rear ears are flush

against the back of the cabinet’s rear rails. Align the holes in the mounting ears with an appropriate set of holes

in the cabinet’s rails, then secure the shelf to the rails using the included mounting hardware.

This manual is also suitable for

Download PDF