3
Alternate parts: (Not supplied with washer)
Your installation may require additional parts. To order, please
refer to the phone number or website on the back page of your
“Use and Care Guide”.
If you have: You will need:
Laundry tub or Sump pump system (if not already
standpipe taller available)
than 96" (2.4 m)
1" (25 mm) 2" (50 mm) diameter to 1" (25 mm)
diameter standpipe diameter Standpipe Adapter Kit,
Part Number 3363920 and
Connector Kit, Part Number 285835
Overhead sewer Standard 20 gal. (76 L) 39” (990 mm)
tall drain tub or utility sink, sump
pump, and connectors (available from
local plumbing suppliers)
Floor drain Siphon Break Kit, Part Number 285834
Drain Hose, Part Number 8318155
Connector Kit, Part Number 285835
Water faucets 2 longer water ll hoses:
beyond reach of 6 ft. (1.8 m), Part Number 76314
ll hoses 10 ft. (3.0 m), Part Number 350008
Lint clogged drain Drain protector, Part Number 376031
LOCATION REQUIREMENTS
You will need:
A water heater set to deliver 120°F (49°C) water to the washer. ■
A grounded electrical outlet located within 4 ft. (1.2 m) of ■
where the power cord is attached to the back of the washer.
See “Electrical Requirements”.
Hot and cold water faucets located within 3 ft. (900 mm) ■
of the hot and cold water ll valves, and water pressure
of 200 psi (138-690 kPa) for best performance.
Level oor with maximum slope of 1" (25 mm) under entire ■
washer. Installing the washer on carpet is not recommended.
A sturdy oor to support the washer weight (washer, water, ■
and load) of 315 lbs (143 kg).
IMPORTANT: Do not operate, install, or store washer where
it will be exposed to water, weather, or at temperatures below
32° F (0° C). Some water can remain in washer and can cause
damage in low temperatures. See your “Use and Care Guide”
for information on winterizing.
Select proper location for your washer to improve performance
and minimize noise and possible “washer walk”. Install your
washer in a basement, laundry room, closet, or recessed area.
Proper installation is your responsibility.
Spacing for recessed area or closet installation
All dimensions show recommended spacing allowed, with tested
spacing of 0" (0 mm) clearance on sides.
Additional spacing should be considered for ease of ■
installation and servicing.
Additional clearances might be required for wall, door, and ■
oor moldings.
Additional spacing should be considered on all sides of the ■
washer to reduce noise transfer.
For closet installation, with a door, minimum ventilation ■
openings in the top and bottom of the door are required.
Louvered doors with equivalent ventilitation openings are
acceptable.
Companion appliance spacing should also be considered. ■
Front view
Side view
Closet door
with vents
* Required spacing
17"*
(432 mm)
1"
(25 mm)
27
1
/
2
"
(699 mm)
1"
(25 mm)
27"
(686 mm)
5"*
(127 mm)
14"* max.
(356 mm)
48 in.
2
*
(310 cm
2
)
24 in.
2
*
(155 cm
2
)
3"*
(76 mm)
3"*
(76 mm)
1"
(25 mm)
