Page is loading ...
3
Instructions for conversion to 30 mbar liquid gas
for model 51AFDK, HFW236
If you want to operate your hob using 30 mbar liquid gas, it must be conver-
ted (adapted).
1 Important: The conversion may only be performed by an authorised gas fit-
ter.
1 Important: Before using for the first time check for leaks.
The conversion set consists of
Performing the conversion
1. Take off pan bracket, both burner covers (disc cover and ring cover) and
burner crown without using tools (fig. 1).
2. Replace the main jet (fig. 2). To do this you will need a 7 mm socket span-
ner.
3. Remove the knob and the rubber seal (fig. 3).
4. Carefully screw in the low setting jet as far as it will go (fig. 3).
5. Use a waterproof pen to label the conversion sticker and stick to the un-
derside of the hob next to the gas connection (fig. 4).
6. As a final check, turn the knob of the burner quickly (in about 1 second)
from the maximum setting to the minimum setting. When you do this, the
flame must not go out.
7. The nozzle should be resealed once successfully switched over.
Name of item Label Number
Main jet for wok burner 98 1
Conversion label - 1
From the Electrolux Group. The world´s No.1 choice.
The Electrolux Group is the world´s largest producer of powered appliances for kitchen, cleaning and outdoor
use. More than 55 million Electrolux Group products (such as refrigerators, cookers, washing machines,
vacuum cleaners, chain saws and lawn mowers) are sold each year to a value of approx. USD 14 billion in
more than 150 countries around the world.
822 930 107-C-280108-03 Subject to change without notice
/