Mammoth P6SP Installation guide

P6SP
Mammoth
Brand
Mammoth
Model
P6SP
Category
Wall & ceiling mounts accessories
Type
Installation guide

This manual is also suitable for

INSTALLATION
INSTRUCTIONS
INSTALLATION INSTRUCTIONS FOR
HOODED HAIL GUARDS 558857 & 559411
USED WITH Q5SN 090-120 UNITS
AND P6 & R6 SERIES 090 UNITS
FORM# 100D-0209 (100D-1208)
The Hail Guard is de signed to pre vent dam age to the con denser coil of the unit. The fol low ing list of parts are re quired:
Step 1:
Check for correct number of parts. See list
below.
1 - Hail Guard (A)
1 - Top Panel (B)
2 - Vertical Side Panel (C)
1 - Hardware Package
12 - #10- 16 x ½ Self-tapping Screws
1 - Installation Instruction
Step 2:
Take vertical side panels (C) and assembly to
the top panel (B).
Step 3:
Secure hail guard (A) in between clips on the
vertical side panels and close clips to hold
guard in position.
Step 4:
Remove support bracket screw at
center front edge of condenser top.
Slip top flange of the assembled kit under the
top pan of the unit and align left side with corner
post of unit. Use the self-tapping screws
supplied with kit to attach to the corner post and
coil mounting panel.
Replace screw to support bracket at center
front edge of condenser top.
WARNING:
If other than supplied screws are
used ensure not to exceed ½" in
length to prevent damage to the
condenser coil.
Fig ure 3
B
C
SUPERSEDES 01-19-09
FEBRUARY 16, 2009
FORM# NEIHG07D
Fig ure 1
B
C
A
NOTCH
Fig ure 2
COIL EDGE
NOTCH
NOTCH
NOTCH
SUPPORT SCREW
  • Page 1 1

Mammoth P6SP Installation guide

P6SP
Mammoth
Brand
Mammoth
Model
P6SP
Category
Wall & ceiling mounts accessories
Type
Installation guide
This manual is also suitable for
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents