2. Western
  3. UltraMount2 Attach/Detach Label Placement

Western UltraMount2 Attach/Detach Label Placement Parts List & Installation Instructions

  • Hello! I have reviewed the provided document which are installation instructions for updating the attach/detach label on a Western Products UltraMount 2 snowplow blade. The document details how to apply a new label if one is missing or needs updating, emphasizing visibility during the attach/detach process. I'm ready to answer your questions about this document or the snowplow.
  • What should I do if my blade does not have an Attach/Detach label with the UltraMount 2 logo?
    Where should I apply the supplied UltraMount 2 Attach/Detach label?
    What if my blade has no current label?
    What do I need to do to prepare the surface for the label?
Lit. No. 43537, Rev. 00 June 1, 2013
Lit. No. 43537, Rev. 00 June 1, 2013
ATTACH/DETACH INSTRUCTIONS LABEL
INSTALLATION INSTRUCTIONS
If your blade does not have an Attach/Detach label
with the UltraMount® 2 logo (shown at right), then
follow the instructions below to update your label.
Apply the supplied UltraMount® 2 Attach/Detach label
directly over the current Attach/Detach label on the
back of the blade.
If the blade has no current label, place the supplied label on the back of the blade, on the
driver's side, in an area visible during the attach and detach procedure. The Warning/Caution
label must remain visible.
Thoroughly clean and dry the existing label or blade surface area before applying the new label.
INSTALLATION INSTRUCTIONS
If your blade does not have an Attach/Detach label
with the UltraMount® 2 logo (shown at right), then
follow the instructions below to update your label.
Apply the supplied UltraMount® 2 Attach/Detach label
directly over the current Attach/Detach label on the
back of the blade.
If the blade has no current label, place the supplied label on the back of the blade, on the
driver's side, in an area visible during the attach and detach procedure. The Warning/Caution
label must remain visible.
Thoroughly clean and dry the existing label or blade surface area before applying the new label.
ATTACH/DETACH INSTRUCTIONS LABEL
Lit. No. 43537, Rev. 00 June 1, 2013
Lit. No. 43537, Rev. 00 June 1, 2013
A DIVISION OF DOUGLAS DYNAMICS, LLC
Western Products reserves the right under its product improvement policy to change construction or design details and furnish equipment
when so altered without reference to illustrations or specications used. Western Products or the vehicle manufacturer may require or
recommend optional equipment for snow removal. Do not exceed vehicle ratings with a snowplow. Western Products offers a limited warranty
for all snowplows and accessories. See separately printed page for this important information. The following are registered (®) trademarks of
Douglas Dynamics, L.L.C.: UltraMount® 2, WESTERN®.
Printed in U.S.A.
A DIVISION OF DOUGLAS DYNAMICS, LLC
Western Products reserves the right under its product improvement policy to change construction or design details and furnish equipment
when so altered without reference to illustrations or specications used. Western Products or the vehicle manufacturer may require or
recommend optional equipment for snow removal. Do not exceed vehicle ratings with a snowplow. Western Products offers a limited warranty
for all snowplows and accessories. See separately printed page for this important information. The following are registered (®) trademarks of
Douglas Dynamics, L.L.C.: UltraMount® 2, WESTERN®.
Printed in U.S.A.
/