RAMPAGE PRODUCTS 3D Grille Insert Installation guide

Hello! I've reviewed the installation instructions for the Quadratec Grille JK 07-09. The document provides a clear step-by-step guide to help you install your new grille, including how to remove the old shell, align the new grille, attach brackets, and reinstall the shell. I'm ready to answer any questions you have about the installation process.
What parts are included in the package?

What is the first step of the installation?

How should the grille be aligned with the shell?

07-09 Jeep JK Grille Installation Instructions

Parts list: 1 grille, 2 - 15” brackets, 4 – 8/32 x 5/8” screws, 4 – 8/32 nylon lock nuts.

Step 1 – Remove front shell. Open the hood, remove rubber clips on top of shell, pull shell out

enough to insert a flat screw driver, remove bottom clips, and signal lights.

Step 2 – Align Grille to Shell. Put the shell face down on a protected surface, place the grille

face down on shell, align the raised sections of grille with the 7 shell openings (IMPORTANT

– Make sure that the notch cutout is facing the bottom of the shell).

Step 3 – Attach brackets. Align the brackets as seen in picture above, apply pressure to bottom

of bracket and drill a 3/16” hole (see figure 1), attach screw and lock nut – do not over tighten.

Repeat steps for second bracket at figure 2. Apply pressure to top of bracket – figure 3

(enough to firmly seat the grill into shell), drill 3/16” hole, insert screw with lock nut on top of

shell. Repeat for figure 4. Be sure to tighten all lock nuts.

1 2 3 4

Step 4 – Reinstall shell with grille attached. Reattach signal lights, align grille shell with holes

and reinsert the rubber clips.

We hope you enjoy your new grille!!