2. BLOTZ
  3. B28-SF-244

BLOTZ B28-SF-244 Assembly Instructions

  • Hello! I've reviewed the instructions for the 28mm Retro Data Storage model, B28-SF-244. This document guides you through the assembly process, from constructing the cabinet to painting the final product. I'm ready to answer any questions you might have about the build.
  • What type of glue is required?
    What tool is needed to remove sections from the sprue?
    What can be used to hold pieces in place while the glue dries?
28mm Retro Data Storage #1
B28-SF-244
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care and
remember to cut away from yourself at all times.
During the construction of this model, you may find it convenient to use pegs / elastic bands to hold pieces in
place while you allow glue to dry.
Take the pieces which make up the rear of the cabinet.
Glue them together as shown to make an open
fronted box.
Stick the support bar into place.
Attach the front of the cabinet.
We now suggest you paint
the components of
your model (see below)
Glue the reels into position.
Glue the front facia plate into place.
Painting
We sprayed the body of the cabinet black while the facia plate and reels were sprayed white – both with car undercoat
primer spray.
The details on the facia plate were then picked out with model paints – using a random colour pattern for the display.
/