0191984 Page 1 of 1
925 FIRST AVENUE, CHIPPEWA FALLS, WI 54729 / 800-235-1262 / 715-723-6750 / WWW.SPECTRUMFURNITURE.COM925 FIRST AVENUE, CHIPPEWA FALLS, WI 54729 / 800-235-1262 / 715-723-6750 / WWW.SPECTRUMFURNITURE.COM
Assembly InstructionsAssembly Instructions
Important
Before you begin, read and comply with all safety and operating instructions,
and ensure all parts and correct quantities are included.
Any parts damaged during shipment must be reported within 5 days of receipt.
To report information regarding missing parts or damage, to purchase parts
or accessories, or if you have any questions, please contact us.
www.spectrumfurniture.com
800-235-1262, 715-723-6750
Thank you for purchasing Spectrum products!
Assembly InstructionsAssembly Instructions
Locking door for Equipment RackLocking door for Equipment Rack
(2) 0119468
Recessed bumper
w/ 1/4” washer
1. Attach door to equipment rack1. Attach door to equipment rack
1. Determine which side of the equipment rack the door will be at-
tached. The locking door is symmetrical and can be mounted to
swing from the left or right-side.
2. With the hinge open, align the mounting holes as shown and attach
to equipment rack frame with (4) 8-32 x 1/2” PH thread-cutting
screws. Be sure the screws are installed straight. Do not tighten
completely until all screws are installed. Figure 1.
Figure 1
55510 - 32”H Acrylic Door55510 - 32”H Acrylic Door
55512 - 39”H Acrylic Door55512 - 39”H Acrylic Door
55509 - 32”H Solid Door55509 - 32”H Solid Door
55511 - 39”H Solid Door55511 - 39”H Solid Door
(6) 0100167
8-32 x 1/2” PH
Thread ctg screw
2. Install bumpers2. Install bumpers
1. With the door open, install each bumper with (1) 8-32 x 1/2” PH
thread-cutting screw to the equipment rack frame (opposite of door)
as shown. Figure 2.
Figure 2
Equipment rack
© 2020 Spectrum Industries Inc., All rights reserved.
8-32 x 1/2” PH
Thread ctg screw
(4 required)
Door
8-32 x 1/2” PH
Thread ctg screw
Recessed bumper
w/ 1/4” washer
