Page is loading ...
Important
Before you begin, please make sure all parts and proper quantities
are included. Any parts damaged during shipment must be reported
within 15 days of receipt. To report information regarding damage, to
purchase parts or accessories, or if you have any questions, please
contact us at:
www.spectrumfurniture.com
715-723-6750, 800-235-1262
Thank you for purchasing Spectrum products!
adhesive
bumper
door
equipment
rack
door
8-32 x 1/2” PH
Thread ctg screw
(4 required)
equipment
rack
0109000R1 Page 1 of 1
Assembly Instructions
925 First Avenue, PO Box 400, Chippewa Falls, WI 54729 Ph: 800-235-1262, 715-723-6750 Fax: 800-335-0473, 715-738-2309
E-mail: [email protected] web: www.spectrumfurniture.com
Assembly Instructions
Locking door for IMC
(2) 044573
5/8” adhesive
bumpers
Phillips
screwdriver
Tools
Required
1. Attach door to equipment rack
1. The locking door is symmetrical and can be mounted to swing
from the left or right-side of the equipment rack. Before you begin,
determine which side the door will be attached.
2. With the hinge open, align the mounting holes as shown and at-
tach to equipment rack frame with (4) 8-32 x 1/2” PH thread cutting
screws. Be sure the screws are installed straight. Do not tighten
completely until all screws are installed. Figure 1.
Figure 1
Drill with
Phillips driver
68103 - 29” Acrylic Door
68153 - 36” Acrylic Door
68102 - 29” Solid Door
68152 - 36” Solid Door
(4) 0100167
8-32 x 1/2” PH
thread ctg screw
2. Install bumpers
1. With the door open, install the (2) adhesive bumpers
onto the equipment rack frame as shown. Figure 2.
Figure 2
Note: If using an electric drill
with Phillips driver to install,
be sure to use the torque
setting to prevent stripping
out the screw holes.
or
/