Page is loading ...
Anybus X-gateway - LonWorks Adapter Interface Network Installation Sheet
www.anybus.comSP1750, rev. 2.00, Apr 2015
Service Pin Button
The Service Pin Button is a pushbutton wired between the service pin
and ground in the LonWorks connector. Pressing the button will send
a service pin message on the LonWorks channel.
Shield
Service
GND
Net A
Net B
Remote Service
Pin Pushbutton
Accessories Checklist
The following items are required for installation:
• LonWorks confi guration tool (not included)
• USB cable (included)
• LonWorks cable (not included)
Installation and Startup Summary
1. Connect the gateway to the network
2. Connect a PC to the gateway via USB (optional)
3. Power up and (if required) confi gure the gateway
Technical Support
Technical support, documentation and software downloads are
available at www.anybus.com.
Technical questions regarding the LonWorks fi eldbus system should
be directed to LonMark International at www.lonmark.org.
LED Indicators
LED Indication Meaning
GW Status See Gateway Installation Sheet
MS
Green Gateway initialized and operating normally
Red Hardware error
Red (fl ashing) Software error - power-cycle gateway to recover
Wink Red (fl ashing) Wink command received
Off Normal state
Service
Green Node is unconfi gured and no application/errors
detected by the Neuron self-test
Green (fl ashing) Node is unconfi gured and has an application
Off Node is confi gured and installed on the network
Top-mounted
GW Status
MS
Wink
Service
GW Status
MS
Wink
Service
USB
(X4)
USB
(X4)
B
otto
m-m
ou
n
ted
Product Overview
The LonWorks Adapter interface can be top- or bottom-mounted.
Both of these options are illustrated below.
Top-mounted Interface
LonWorks Connector (X1)
Service Pin Button
Power Connector (X3)
Bottom-mounted Interface
LonWorks Connector (X2)
Service Pin Button
LonWorks Connector
Pin Signal
51
1 Shield
2 GND
3 Service pin
4 NET B
5 NET A
/