2. LEDPRO
  3. BY NORLUX TIGRUS 360 D2W DOWNLIGHT, SVART

LEDPRO BY NORLUX TIGRUS 360 D2W DOWNLIGHT, SVART Installation guide

  • Hello! I've reviewed the installation manual for the Ledpro 80x83mm downlight, and I'm ready to help you with any questions you might have about the installation process. The document includes step-by-step guidance on safe electrical connection, cutting hole, driver conection and mounting the downlight.
  • What is the cutout size required for the downlight?
    What should I do before starting the installation?
    Can I modify the wiring of the light fitting?
ledpro.no
Installasjonsmanual / Installation manual
• Ensure the power to the circuit being used is disconnected and will stay disconnected until the job is completed.
• Make sure the mounting surface is strong enough to carry the weight of the tting and the strength of the springs.
• Do not remove the cover or any part to modify wiring as this will not only compromise the IP rating but also warran terms.
Compromising with IP rating may lead to premature failure of the product.
Cut o the power supply before
start.
Cut out a hole in the ceiling at a
certain diameter given in the box
label.
Connect the line of 230V to the AC
input of the driver.
Connect the light to the driver via
the plug.
Put the driver onto the ceiling, then
pull the springs into vertical state.
Release the springs, it will lock the
lamp on the ceiling.
Turn on the power supply.
Insert the springs as well as the
lamp.
Ledpro by Norlux
Borgeskogen 32
3160 Stokke, Norway Page 1/2
ledpro.no
+47 33 30 10 80
[email protected]
Cutout: 80X83mm
ledpro.no
Safe Warnings, Precautions & Limitations:
Safe Warnings, Precautions & Limitations:
• The product must be installed, maintained and operated as per manufacturer’s instructions.
• Before starting installation of this product, make sure power supply is DISCONNECTED.
• Do not install the product if it appears damaged in anyway, check with manufacturer if in doubt.
• This product must be installed by a licensed electrician.
• Do not cover UNLESS manufacturer otherwise states the tting is suitable.
• Inspect the tting regularly. Any damage to the light tting, immediately cease use of the tting.
• Do not modify this tting in any matter as this will void warran.
• Check protection class, if class I, it must be earthed.
• Check tting application suitabili for indoor or outdoor use. Refer to IPXX or check with the manufacturer if in doubt.
• DISCONNECT FROM POWER SUPPLY BEFORE any maintenance or cleaning.
• Do not Megger between Line and Neutral.
Ledpro by Norlux
Borgeskogen 32
3160 Stokke, Norway Page 2/2
ledpro.no
+47 33 30 10 80
[email protected]
/