Page is loading ...
Page is loading ...
- 1 -
1. Before assembling parts, please check the parts quantity according to
the PARTS LIST.
2. Carefully unpack and spread out all parts in a large uncluttered area.
3. Familiarize yourself with all parts and compare them with the drawing
below to make sure none are missing. Read all assembly instructions
before beginning.
PARTS LIST
A) Keys
B) Top Mats & Drawer liner
C) 4 Casters (2 swivel locking, 2 swivel)
D) 16 Caster Bolts (M8 x 14)
16 Caster washers
16 Spring Washers for Casters
E) 4 Legs
F) 4 Leg Bumpers
G) 40 Bolts for legs and bumpers (M8x17)
40 Washers for legs and bumpers
40 Non-nylon nuts for legs and bumpers
40 Spring washers for legs and bumpers
H) 1 Shelf
I) 1 Push handle
J) 4 Push Handle Bolts (M8x19)
4 Washers for push handle
4 Nylon Locknuts for push handle
A) B)
C) D)
E) F)
G)
J)
H)
I)
THANK YOU FOR PURCHASING A HOMAK UNIT.
WE APPRECIATE YOUR BUSINESS.
Congratulations on your new purchase!
Before operating your unit, please read the following carefully.
KEEP INSTRUCTION MANUAL IN A SAFE PLACE UPON OPENING YOUR NEW UNIT.
THE KEY CODE TO YOUR HMC SECURE PREMIUM TUBULAR LOCK CAN BE FOUND
ON THE BACK OF THIS MANUAL. IF THIS CODE IS LOST, PLEASE CALL 1-800-874-
6625 FOR ASSISTANCE.
For Replacement Parts, Technical Troubleshooting, or Sales & Service, please call
1-800-874-6625 and a representative will assist you.
- 2 -
ASSEMBLY
* We recommend that TWO PEOPLE work together on the assembly,
due to the weight of this cart. Cart weight is approximately 170 lbs,
please be careful during assembly.
1. Locate the key tied to the bottom tray. Using the key, open the slide-
top lid and remove the caster box from the bottom drawer. After removal,
make sure all drawers are completely closed and the inside lever is in the
locked position. Close and lock the slide-top lid.
2. Using the protective foam provided, lay out a work surface. Gently turn
the cart upside down so the slide-top is on the foam surface.
3. (Before assembling the legs remove the cable
tie holding the bumper in place). Insert the front
leg (Part E), labeled FL or FR into top lip of the
cart. Then place the Front bumper (Part F) over
the leg aligning the center bolt holes. With holes
aligned insert stove bolt (Part G) and nger tighten
with washer, spring washer and then the nut.
4. Install back leg (Part E) labeled BL or BR and
bumper (Part F) following the same procedure as
above. Note: Make sure the back leg is inside the
hinge rivet. Otherwise the holes will not line up
during assembly.
5. Repeat steps 3 & 4 to mount the legs on the
opposite side.
6. Completely tighten the 8 bolts just inserted.
7. Insert bottom shelf (Part H) between the four
legs at side facing up towards the ceiling (be-
cause cart is assembled upside down).
Insert sixteen stove bolts, washers, spring wash-
ers and nuts (Part G) and completely tighten.
8. Mounting casters: Put the four casters in place.
The two locking casters should be on one side of
the cart and the two non locking casters should be
on the other (Left or right side NOT front or back).
Step 4
Step 6
Step 7
- 3 -
Using the 16 bolts (Part D), washers and spring
washers, completely tighten the casters to the
bottom tray using a 14mm socket and 14mm
combination wrench for the bolt head.
9. Carefully turn cart onto its casters
10. Open slide-top lid using the key provided.
11. Mount push handle (Part I) to the same side
of the cart with the locking casters using the
four stove bolts, washers and locknuts (Part J)
provided.
12. Insert the remaining 12 stove bolts, wash-
ers, spring washers and nuts (Part G).
13. Using 13mm socket completely tighten all
installed hardware.
Step 8
Step 11
Step 12
- 4 -
MAINTENANCE
Ball-Bearing Slides
Note: Unload drawer prior to drawer removal.
Never overload drawers.
To remove drawers and slides, pull drawer all the way out, depress the
black drawer release levers on each slide. For ball-bearing glides, there is
one black lever per slide. One black lever will be pushed down and the
other will be pushed up for drawer removal. After levers are pushed, the
drawer is released. Pull out drawer all the way for removal.
To re-install the drawer, insert guides on drawer side into slides and rmly
close drawer all the way.
To maintain the smooth and quiet operation of the ball-bearing slides,
lubricate the extension track that houses the ball bearings every 3-6
months with a high quality jelly-like petroleum based lubricant.
Powder Coat Finish
For heavy build-up of dirt and grime, our powder coat paint nish can be
cleaned with spray wax. Lightly spray the wax on the surface, and gently
wipe with a soft, dry microber cloth.
Window cleaner and a soft cloth dampened with water can be used to
clean the nish on a regular basis.
Customer Satisfaction
All mechanical parts are inspected and adjusted for proper use before
shipment; however, mechanisms such as drawer slides and locks may
shift during transit. Should any of these items not operate correctly,
please call customer assistance at 1-800-674-6625.
PRODUCT MADE IN CHINA
PRODUIT FABRIQUÉ EN CHINE
PRODUCTO FABRICADO EN CHINA
LEFT DRAWER RELEASE
LEVIER DE TIROIR GAUCHE
PALANCA DEL CAJÓN IZQUIERDO
LEFT DRAWER RELEASE
LEVIER DE TIROIR GAUCHE
PALANCA DEL CAJÓN IZQUIERDO
RIGHT DRAWER RELEASE
LEVIER DE TIROIR DROIT
PALANCA DEL CAJÓN DERECHO
RIGHT DRAWER RELEASE
LEVIER DE TIROIR DROIT
PALANCA DEL CAJÓN DERECHO
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
- 14 -
PLEASE KEEP IN A SAFE AND SECURE PLACE AWAY FROM CHILDREN.
GARDER DANS UN ENDROIT SÛR, LOIN DES ENFANTS.
POR FAVOR MANTENERSE EN UN LUGAR APROPIADO Y SEGURO LE JOS DE LOS NIÑOS.
FACTORY CODE:
CODE D’USINE :
CÓDIGO DE FÁBRICA : ____________________________________________
PRODUCT REGISTRATION
Thank you for purchasing this quality HOMAK product. Please take the time to register your manu-
facturer’s code and product by calling 1-800-874-6625 or by visiting www.homak.com and clicking the
“Product Registration” link.
This will allow us to better assist you in the future for:
- Parts - Warranty claims - Other product concerns -Troubleshooting
Please Read Entire Instruction Manual Before Operating Unit In Order to Assure Proper Warranty Coverage
ENREGISTREMENT DU PRODUIT
Merci d’avoir acheté ce produit de qualité HOMAK. Nous vous prions de prendre le temps d’enregistrer
le code du fabricant et du produit en composant le 1-800-874-6625 ou en visitant www.homak.com et en
cliquant sur le lien « Product Registration » (en anglais seulement).
Cela nous permettra de mieux vous aider à l’avenir pour :
- les pièces - les réclamations sous garantie - d’autres questions sur le produit
- les dépannages
Lire tout le mode d’emploi avant de faire fonctionner l’unité, an d’assurer une couverture adéquate de
la garantie.
EL REGISTRO DEL PRODUCTO
Gracias por adquirir este producto de calidad HOMAK.
Por favor tome el tiempo de registrar su código y su producto de empresa llamando a 1-800-874-6625
ó visitando:
www.homak.com y marcando el enlace “Registro de producto”.
Esto nos permitirá de asistirle mejor en lo futuro por:
- Partes - Reclamaciones de garantía - Otras preocupaciones sobre el producto
- Intervención para arreglar problemas
Por favor leer completamente el manual de instrucción antes de operar el aparato de manera a asegurar
la cobertura apropiada de la garantía.
Homak Manufacturing
1605 Old Route 18 Suite 4-36
Wampum, PA 16157
1-800-874-6625
PRODUCT MADE IN CHINA
PRODUIT FABRIQUÉ EN CHINE
PRODUCTO FABRICADO EN CHINA
www
com
Hours of operation: Heures d’ouverture : Horas de apertura
Monday - Friday Du lundi au vendredi De lunes a viernes
8:30 a.m. - 4:30 p.m. 8h30 à 16h30 8h30 am a 4h30 pm
Eastern Time Heure de l’Est Hora del este
THIS PRODUCT CARRIES A LIMITED 5 YEAR WARRANTY FOR PARTS
PLEASE CALL 1-800-874-6625 OR VISIT WWW.HOMAK.COM FOR WARRANTY
OR PART REPLACEMENT QUESTIONS
LES PIÈCES DE CE PRODUIT ONT UNE
GARANTIE LIMITÉE DE 5 ANS
COMPOSER LE 1-800-874-6625 OU VISITER WWW.HOMAK.COM POUR
TOUTE QUESTION SUR LA GARANTIE OU LES PIÈCES DE REMPLACEMENT.
LAS PIEZAS DE ESTE PRODUCTO LLEVAN
UNA GARANTÍA LIMITADA DE 5 AÑOS
POR FAVOR LLAME AL 1-800-874-6625 O VISITE WWW.HOMAK.COM PARA
LAS PREGUNTAS DE LA GARANTÍA O DEL REEMPLAZO DE LA PARTES.
Rev 1.2
/
