ATD-7020
2 SHELF SERVICE CART
ASSEMBLY INSTRUCTIONS
Service Cart Assembly Instructions:
1. Slide chrome legs (#2) into square holes cut in tray (#1) until bolt holes are
aligned at top of legs.
2. Insert bolt (#6) into hole on leg and tray. Fasten nut (#10) using lock washer
(#9) and flat washer(#8), but do not tighten nut completely at this time.
Repeat this procedure on all four corners.
3. Repeat step 1 with second tray (#1) at bottom of legs.
4. Repeat step 2 with bottom tray (#1)
5. Insert casters (#4) into the hole of plastic insert(#5). Note: Insert the two
locking caster (#3) at the same end of the cart.
6. Now go back and tighten all loose nuts and bolts.
Item No# Description Q’ty
PRT7020-01 Tray 2
PRT7020-02 Chrome Leg 2
PRT7020-03 Locking Casters 2
PRT7020-04 Non-Locking Casters 2
PRT7020-05 Set of 4 Plastic Insert 1
PRT7020-06 Bolt Kit (Incl. 8 ea. Of #8, 9 & 10) 1
Optional Accessories Also Available:
ATD7021 Locking Drawer
PRT7021-01 Drawer Handle
PRT7021-02 Drawer Lock with Keys
PRT7021-03 Drawer Rail
ATD7138 Locking Screwdriver Holder
PRT7138-01 Lock with Keys for Holder
/
