Homak 35 Inch 4 DRAWER SLIDE TOP CART - RED RD06043500 User manual

Page is loading ...

- 1 -

1. Before assembling parts, please check the parts quantity according to

the PARTS LIST.

2. Carefully unpack and spread out all parts in a large uncluttered area.

3. Familiarize yourself with all parts and compare them with the drawing

below to make sure none are missing. Read all assembly instructions

before beginning.

PARTS LIST

A) Keys

B) Top Mats & Drawer liner

C) 4 Casters (2 swivel locking, 2 swivel)

D) 16 Caster Bolts (M8 x 14)

16 Caster washers

16 Spring Washers for Casters

E) 4 Legs

F) 4 Leg Bumpers

G) 40 Bolts for legs and bumpers (M8x17)

40 Washers for legs and bumpers

40 Non-nylon nuts for legs and bumpers

40 Spring washers for legs and bumpers

H) 1 Shelf

I) 1 Push handle

J) 4 Push Handle Bolts (M8x19)

4 Washers for push handle

4 Nylon Locknuts for push handle

A) B)

C) D)

E) F)

G)

J)

H)

I)

THANK YOU FOR PURCHASING A HOMAK UNIT.

WE APPRECIATE YOUR BUSINESS.

Congratulations on your new purchase!

Before operating your unit, please read the following carefully.

KEEP INSTRUCTION MANUAL IN A SAFE PLACE UPON OPENING YOUR NEW UNIT.

THE KEY CODE TO YOUR HMC SECURE PREMIUM TUBULAR LOCK CAN BE FOUND

ON THE BACK OF THIS MANUAL. IF THIS CODE IS LOST, PLEASE CALL 1-800-874-

6625 FOR ASSISTANCE.

For Replacement Parts, Technical Troubleshooting, or Sales & Service, please call

1-800-874-6625 and a representative will assist you.

- 2 -

ASSEMBLY

* We recommend that TWO PEOPLE work together on the assembly,

due to the weight of this cart. Cart weight is approximately 170 lbs,

please be careful during assembly.

1. Locate the key tied to the bottom tray. Using the key, open the slide-

top lid and remove the caster box from the bottom drawer. After removal,

make sure all drawers are completely closed and the inside lever is in the

locked position. Close and lock the slide-top lid.

2. Using the protective foam provided, lay out a work surface. Gently turn

the cart upside down so the slide-top is on the foam surface.

3. (Before assembling the legs remove the cable

tie holding the bumper in place). Insert the front

leg (Part E), labeled FL or FR into top lip of the

cart. Then place the Front bumper (Part F) over

the leg aligning the center bolt holes. With holes

aligned insert stove bolt (Part G) and nger tighten

with washer, spring washer and then the nut.

4. Install back leg (Part E) labeled BL or BR and

bumper (Part F) following the same procedure as

above. Note: Make sure the back leg is inside the

hinge rivet. Otherwise the holes will not line up

during assembly.

5. Repeat steps 3 & 4 to mount the legs on the

opposite side.

6. Completely tighten the 8 bolts just inserted.

7. Insert bottom shelf (Part H) between the four

legs at side facing up towards the ceiling (be-

cause cart is assembled upside down).

Insert sixteen stove bolts, washers, spring wash-

ers and nuts (Part G) and completely tighten.

8. Mounting casters: Put the four casters in place.

The two locking casters should be on one side of

the cart and the two non locking casters should be

on the other (Left or right side NOT front or back).

Step 4

Step 6

Step 7

- 3 -

Using the 16 bolts (Part D), washers and spring

washers, completely tighten the casters to the

bottom tray using a 14mm socket and 14mm

combination wrench for the bolt head.

9. Carefully turn cart onto its casters

10. Open slide-top lid using the key provided.

11. Mount push handle (Part I) to the same side

of the cart with the locking casters using the

four stove bolts, washers and locknuts (Part J)

provided.

12. Insert the remaining 12 stove bolts, wash-

ers, spring washers and nuts (Part G).

13. Using 13mm socket completely tighten all

installed hardware.

Step 8

Step 11

Step 12

- 4 -

MAINTENANCE

Ball-Bearing Slides

Note: Unload drawer prior to drawer removal.

Never overload drawers.

To remove drawers and slides, pull drawer all the way out, depress the

black drawer release levers on each slide. For ball-bearing glides, there is

one black lever per slide. One black lever will be pushed down and the

other will be pushed up for drawer removal. After levers are pushed, the

drawer is released. Pull out drawer all the way for removal.

To re-install the drawer, insert guides on drawer side into slides and rmly

close drawer all the way.

To maintain the smooth and quiet operation of the ball-bearing slides,

lubricate the extension track that houses the ball bearings every 3-6

months with a high quality jelly-like petroleum based lubricant.

Powder Coat Finish

For heavy build-up of dirt and grime, our powder coat paint nish can be

cleaned with spray wax. Lightly spray the wax on the surface, and gently

wipe with a soft, dry microber cloth.

Window cleaner and a soft cloth dampened with water can be used to

clean the nish on a regular basis.

Customer Satisfaction

All mechanical parts are inspected and adjusted for proper use before

shipment; however, mechanisms such as drawer slides and locks may

shift during transit. Should any of these items not operate correctly,

please call customer assistance at 1-800-674-6625.

PRODUCT MADE IN CHINA

PRODUIT FABRIQUÉ EN CHINE

PRODUCTO FABRICADO EN CHINA

LEFT DRAWER RELEASE

LEVIER DE TIROIR GAUCHE

PALANCA DEL CAJÓN IZQUIERDO

LEFT DRAWER RELEASE

LEVIER DE TIROIR GAUCHE

PALANCA DEL CAJÓN IZQUIERDO

RIGHT DRAWER RELEASE

LEVIER DE TIROIR DROIT

PALANCA DEL CAJÓN DERECHO

RIGHT DRAWER RELEASE

LEVIER DE TIROIR DROIT

PALANCA DEL CAJÓN DERECHO

Page is loading ...

- 14 -

PLEASE KEEP IN A SAFE AND SECURE PLACE AWAY FROM CHILDREN.

GARDER DANS UN ENDROIT SÛR, LOIN DES ENFANTS.

POR FAVOR MANTENERSE EN UN LUGAR APROPIADO Y SEGURO LE JOS DE LOS NIÑOS.

FACTORY CODE:

CODE D’USINE :

CÓDIGO DE FÁBRICA : ____________________________________________

PRODUCT REGISTRATION

Thank you for purchasing this quality HOMAK product. Please take the time to register your manu-

facturer’s code and product by calling 1-800-874-6625 or by visiting www.homak.com and clicking the

“Product Registration” link.

This will allow us to better assist you in the future for:

- Parts - Warranty claims - Other product concerns -Troubleshooting

Please Read Entire Instruction Manual Before Operating Unit In Order to Assure Proper Warranty Coverage

ENREGISTREMENT DU PRODUIT

Merci d’avoir acheté ce produit de qualité HOMAK. Nous vous prions de prendre le temps d’enregistrer

le code du fabricant et du produit en composant le 1-800-874-6625 ou en visitant www.homak.com et en

cliquant sur le lien « Product Registration » (en anglais seulement).

Cela nous permettra de mieux vous aider à l’avenir pour :

- les pièces - les réclamations sous garantie - d’autres questions sur le produit

- les dépannages

Lire tout le mode d’emploi avant de faire fonctionner l’unité, an d’assurer une couverture adéquate de

la garantie.

EL REGISTRO DEL PRODUCTO

Gracias por adquirir este producto de calidad HOMAK.

Por favor tome el tiempo de registrar su código y su producto de empresa llamando a 1-800-874-6625

ó visitando:

www.homak.com y marcando el enlace “Registro de producto”.

Esto nos permitirá de asistirle mejor en lo futuro por:

- Partes - Reclamaciones de garantía - Otras preocupaciones sobre el producto

- Intervención para arreglar problemas

Por favor leer completamente el manual de instrucción antes de operar el aparato de manera a asegurar

la cobertura apropiada de la garantía.

Homak Manufacturing

1605 Old Route 18 Suite 4-36

Wampum, PA 16157

1-800-874-6625

PRODUCT MADE IN CHINA

PRODUIT FABRIQUÉ EN CHINE

PRODUCTO FABRICADO EN CHINA

www

com

Hours of operation: Heures d’ouverture : Horas de apertura

Monday - Friday Du lundi au vendredi De lunes a viernes

8:30 a.m. - 4:30 p.m. 8h30 à 16h30 8h30 am a 4h30 pm

Eastern Time Heure de l’Est Hora del este

THIS PRODUCT CARRIES A LIMITED 5 YEAR WARRANTY FOR PARTS

PLEASE CALL 1-800-874-6625 OR VISIT WWW.HOMAK.COM FOR WARRANTY

OR PART REPLACEMENT QUESTIONS

LES PIÈCES DE CE PRODUIT ONT UNE

GARANTIE LIMITÉE DE 5 ANS

COMPOSER LE 1-800-874-6625 OU VISITER WWW.HOMAK.COM POUR

TOUTE QUESTION SUR LA GARANTIE OU LES PIÈCES DE REMPLACEMENT.

LAS PIEZAS DE ESTE PRODUCTO LLEVAN

UNA GARANTÍA LIMITADA DE 5 AÑOS

POR FAVOR LLAME AL 1-800-874-6625 O VISITE WWW.HOMAK.COM PARA

LAS PREGUNTAS DE LA GARANTÍA O DEL REEMPLAZO DE LA PARTES.

Rev 1.2

Homak 35 Inch 4 DRAWER SLIDE TOP CART - RED RD06043500 User manual

This manual is also suitable for

Homak 35 Inch 4 DRAWER SLIDE TOP CART - RED RD06043500 User manual

in other languages

Related papers

Other documents