Kanguru SATA adaptor Owner's manual

Serial ATA Adapter Kit Quick Start Guide

Clone 4HD SATA Kit Shown

Source Adapter: Connects to the source port on the clone machine.

Target Adapter: Connect to the target ports on the clone machine.

Power Connector: Power must be connected to each adapter for them to work with

the drives. Connect the white connector from the power cable to the side of the

adapter.

Serial ATA Port: Connect one end of the Serial ATA cable to the top of the adapter

and the other end of the cable to the drive.

Installation: Once all the cables are plugged into the adapter, the power connector

will connect to a power port on the clone machine. The Serial ATA data cable and

power connector will connect to the hard drive. Plug the IDE to SATA adapter

directly into an IDE port on the clone machine.

Download PDF