PAC BKLLSK582 User manual

PAC
Brand
PAC
Model
BKLLSK582
Category
Car kits
Type
User manual

This manual is also suitable for

LLSK582 Mounting Kit
Lincoln
2000-06 LS
Ford
2002-05 THUNDERBIRD
VEHICLE APPLICATIONS
CUSTOMER HELP LINE
8am-4:30 P.S.T. Monday-Friday Except Holidays
USA 800-323-4329 • Canada 800-245-8777
iLLSK582
Automotive Products Division
1040 Avenida Acaso • Camarillo, CA 93012, U.S.A.
For information about other American International automotive
accessories visit our website at:
http://www.americaninternational.net
©2012 AMERICAN INTERNATIONAL INDUSTRIES, INC.
TECH Ver. 4/12 PRINT Ver. 4/12
1. Gently pry outward on the upper heater, A/C vents above the radio and remove.
2. Remove the (2) 5/16 bolts securing the top of the radio/climate control
assembly to the sub-dash.
3. Gently pry outward on the top edges of the trim around the ashtray
and remove.
4. Remove the (2) 9/32 bolts securing the ashtray assembly or 12V receptacle panel.
Carefully slide the ashtray assembly outward, disconnect the lighter harness and
remove the assembly.
5. Remove the (2) 5/16 bolts at the bottom of the radio/climate control assembly.
6. Carefully pull the radio/climate control assembly forward, disconnect all
harnesses from the radio and climate controls and remove the assembly.
7. Remove the (6) 4mm or (6) #8 torx screws securing the factory radio to
the assembly and remove the radio from the assembly.
1. Attach the left and right brackets in the kit to the rear of the kit face using
the hardware supplied in the kit (4) small phillips screws.
2. Place the Double DIN radio between the left & right mounting brackets
& slide the radio forward or back for best look & secure the radio to the brackets
using (8) screws supplied with new radio or kit.
3. Remove the 3 locator posts on the top of the climate controls to allow the
kit to rest flush on top of the climate controls (See Figure A below).
4. Loosen the top (2) phillips screws on the side of the climate control module.
5. Place the kit on top of the Climate controls, between the factory brackets.
6. Secure the kit to the factory brackets using (2) small screws supplied with kit.
(See illustration below or on page 3 for your bracket setup.)
7. Make sure the front locator tabs from the left and right mounting brackets
are in the correct holes on the factory brackets. (See illustration below or page 3).
8. Tighten climate control screws.
Figure A
DASH DISASSEMBLY INSTRUCTIONS
KIT ASSEMBLY INSTRUCTIONS
CLIMATE CONTROLS
Figure A
Metal stamped stubs
locate in these (2) holes.
Factory mounting brackets
KIT ASSEMBLY INSTRUCTIONS
2000-2006 LINCOLN LS
2000-2006 LINCOLN LS / 2002-2005 FORD THUNDERBIRD
CLIMATE CONTROLS
Locator Tab Holes
Locator Tab
2 3
Locator Posts
Locator Posts
Metal stamped stubs
locate in these (2) holes.
Figure A
Metal stamped stubs
locate in these (2) holes.
Screw Hole
Factory mounting brackets
KIT ASSEMBLY INSTRUCTIONS
2002-2005 FORD THUNDERBIRD
CLIMATE CONTROLS
Locator Posts
Screw Hole
Screw Hole
Screw Hole
  • Page 1 1
  • Page 2 2

PAC BKLLSK582 User manual

PAC
Brand
PAC
Model
BKLLSK582
Category
Car kits
Type
User manual
This manual is also suitable for
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents