POWERNAIL 20FS Installation guide

Powernail Trigger-Pull Stapler

Use only Powernail® 1” Staples.

Adjust the Stapler FLEX foot to the profile of your flooring (See pictures).

Install your tongue and grove flooring one strip at a

time. Staple each end of the board and then staple

along the board tongue with 4” to 6” inches

between staples.

Set the next of board strip down and tap the boards

so the tongue and groove edges are tight.

At the end of each row, you will need to cut the last

board down to size so that it completes your row

evenly up to the wall.