2. Binary
  3. B-320-1CAT-HDIR-W

Binary B-320-1CAT-HDIR-W, B-320-1CAT-HDIR User guide

  • Hello! I am an AI chatbot trained to assist you with the Binary B-320-1CAT-HDIR-W User guide. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
© 2012 Binary Rev: 121206-1640
Application Guide
B-320-1CAT-HDIR-W Extender IR Integration
0
1
2
3
4
5
6
7
IR InputsIR Outputs
IR Processor / Controller
A
C
Cat5/Cat6 Link
C
B
B-320-1CAT-HDIR-W
Transmitter
B-320-1CAT-HDIR-W
Receiver
PLAY
C
or
Transmitter - IR Control In (3.5mm {1/8”} Mono)
A
IR Flasher Out (3.5mm {1/8”} Mono)
C
Receiver - IR Receiver In (3.5mm {1/8”} Stereo)
B
If the system requires connection to an Automation System or Connecting Block, the included IR
Adapter Cable must be used between the IR Receiver port (B), and the mono connection on the
Automation System or Connecting Block. DO NOT connect a mono cable to this connection without
the adapter, as damage may occur.
The most common use of the IR Control port (A) on the Transmitter, is to send an IR signal from an
Automation System to an IR Flasher (C) connected to the Receiver. This connection does not
include power for an IR Receiver. If the system requires a powered IR Receiver at the Transmitter, a
powered IR Block (ex: SnapAV KIT-IR-RPTR-1X4) will be needed between the IR Receiver and the
Transmitters IR Control In.
The most common use of the IR Receiver port (B) on the Receiver, is to send an IR signal from a
powered IR Receiver to an IR Flasher (C) connected to the Transmitter. This connection includes
+9V DC power for an IR Receiver via A 3.5mm {1/8”} Stereo Cable. DO NOT connect a mono cable
to this connection as damage may occur.
IR Signal (Tip)
GND (Ring)
9V DC (Sleeve)
IR Signal Tip
GND (Ground) Ring
+9V DC Sleeve
IR Signal (Tip)
GND (Sleeve)
IR Signal Tip
GND (Ground) Ring
IR Signal (Tip)
GND (Sleeve)
IR Signal Tip
GND (Ground) Ring
IR Signal (Tip)
GND (Ring)
9V DC (Sleeve)
IR Signal (Tip)
GND (Sleeve)
To IR Receiver In
To IR Control System
or Connecting Block
Note: Arrow Direction Indicates Signal Flow
/