Position the parts as shown and
start the bolt through top onto
the FSA-2 Assembly.
If cords are to be passed through,
lift the FSA-2 assembly and insert
as shown.
Once cords are passed
through, center the FSA-2
assembly in the hole and
tighten to the top using a
3/16” Hex Wrench or Socket.
1 2
3
9A460001
Installation Instructions
INS-9A460001 (Rev.B)
Tools required:
3/16” Hex Wrench or Socket
Note: Flat monitor weight not to exceed 25 lbs.
Parts Included:
(1) Flat Screen Monitor Arm
(2) 5/16-18 Connector Nuts
Midmark Corporation | 60 Vista Drive | PO Box 286 | Versailles, Ohio 45380-0286 | USA | midmark.com
