TMI Products 64-68 Mustang Trunk Kit Installation guide

Brand
TMI Products
Model
64-68 Mustang Trunk Kit
Type
Installation guide
1964-68 Mustang Trunk Kit Installaon
Parts Needed:
1. Permanent Marker
2. Drill
3. Phillips Screwdriver
4. Ratchet Wrench
5. Cap Screws
1.
2.
4.
5.
Last Step: Make sure all panels are ed
correctly and in place, close trunk soly
to make sure it locks in place. Aer Install,
Your trunk should now look like the one in
Photo 7.
2.
3.
4.
5. 6.
7.
3.
1.
Step 1. Lay wood panel, and carpet down, make sure to align with trunk layout.
Step 2. Fit back trunk panel (Refer to Picture 2)
Step 3. Proceed to place inner panel (use picture 3-4 for reference)
Step 4. Line up right and le side trunk panels, sck velcro to hold in place.(Picture 5-6)
Step 5. Make sure all panels are aligned and ed correctly, once secured in place,
You can now begin to install the Trunk Deck Lid. (Page 2)
Part # 99-T7000-000
QP 09-274 / Rev. 01
TRUNK DECK-LID INSTALL
Step 1:
Remove your
trunk lid and
trace hinges
so trunk ts
exact aer
install
Step 2:
Use your
marker to
mark your
drill holes and
drill.
Step 3:
Align your
panel with the
drill holes,
attach panel
w/ Cap
Screws
Step 4:
Use your
Ratchet to
attach lid to
trunk, tighten
bolts.
When Finished with
Step 4, Your trunk should
like the one pictured on
the right!
Enjoy your new TMI
trunk kit!
1.
2.
3.
4.
5.
6.
7. 8.
Note: Deck Lid install was done on a
camaro, Lid install process is the same
for Mustang Lid install.
Part # 99-T7000-000
QP 09-274 / Rev. 01
  • Page 1 1
  • Page 2 2

TMI Products 64-68 Mustang Trunk Kit Installation guide

Brand
TMI Products
Model
64-68 Mustang Trunk Kit
Type
Installation guide
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents