Eizo RP-911, RP-904, RP-912, RP-913 User manual

  • Hello! I am an AI chatbot trained to assist you with the Eizo RP-911 User manual. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
Note
•Surfaceofthepanelprotectorcatchesthedirt(dustorngerprints)easily.Pleaseusetheenclosedgloveswhileinstalling
andremovingthepanelprotector.
•PleaseusethesuppliedmaskingtapeandbecarefulnottoscratchtheLCDpanelorthecabinetwiththepanelprotector
duringinstallation.Alsopleasedonotremovethepanelprotectoroften.ItmayscratchorresultindamagetotheLCD
panel.
•WhenusingLCDmonitorwithoptionalpanelprotector,itispreferabletoavoidusingdownwards.Inthiscondition,the
panelprotectormightbecomebendorslipoutfromthemonitor.
•IfusingtheIntegratedFrontSensorafterinstallationofapanelprotector,besuretoexecutecorrelationusingRadiCS/
RadiCSLE.RefertoeachUser’sManualfordetails.
Installation
Before installation, please remove dust and stains from the LCD panel.
1. 2. 3.
Lever
Tape
(2)
(1)
(1)
(2)
Cut (RP-911/RP-913)
Cut (RP-912)
Cut
(RP-904)
1. Stripthetapefromtheseparatorandadhereitoneachedgeofthecabinet(ontherightandleft).
WithRP-904/RP-911/RP-913,adherethetapeonlongsidesofthecabinet;withRP-912,adherethetapeonshortsidesofthecabinet.
2. Setthepanelprotectorintothegroovesofthepanelframe;thelowerrst(1),thentheupper(2).
Thepanelprotectorhasacuttotonthesensor.Alignthecutwiththesensorpositionwheninstallingthepanelprotector.Ifinstalled
inthewrongorientation,thesensormaybedamaged.
3. Withtheenclosedtool(Lever)setthetabsofthepanelprotectorintothesidegrooves(4tabs/6tabs).
PuttheleveronthetabsofthepanelprotectorandmoveittowardtheLCDpaneltoinstall.PositiontheprotectorintotheLCDpanel
tightlywithoutleavinganopening.
4. Stripthetapefromthecabinet.
Removing
Puttheleveronthetabsofpanelprotectorandmoveittowardthecabinettoremove.
Cleaning
Note
•Pleasebesuretokeepthepanelprotectorimmobilizedwhilecleaningit.OtherwiseitmayscratchthesurfaceoftheLCD
panel.Toholdthepanelprotectorbyhand,useglovesorasoftclothtoavoiddustorngerprints.
•Chemicalssuchasalcoholandantisepticsolutionmaycauseglossvariation,tarnishing,andfadingofthecabinetorpanel,
andalsoqualitydeteriorationoftheimage.
•Neveruseanysolventsorchemicals,suchasthinner,benzene,wax,andabrasivecleaner,whichmaydamagethecabinetor
panel.
Thisproductcomeswithaspecialcleaningclothdesignedtoremovestainsfromthepanel.
Ifnecessarystubbornstainscanberemovedbymoisteningpartoftheclothwithwatertoenhanceitscleaningpower.
Tips
•ItisrecommendedtouseEIZOcleaningkit“ScreenCleaner”(option)tocleanthepanel.
Specification
Surface treatment
Anti-Reective Coating (Both sides)
Coating strength
4H
Reectivity
Less than 0.8 %
Light transmission
More than 95.0 %
Dimension/ Weight
RP-904/RP-911: 341.5 mm (W) × 425.7 mm (H) × 1.5 mm (D) / Approx. 290 g
RP-912: 435.6 mm (W) × 328.0 mm (H) × 1.2 mm (D) / Approx. 210 g
RP-913: 329.0 mm (W) × 437.1 mm (H) × 1.2 mm (D) / Approx. 210 g
Accessories
Lever (for Panel Protector), Gloves, Cleaning Cloth, User’s Manual, Masking tape 4 pieces (2 sets)
Copyright© 2012 EIZO NANAO CORPORATION All rights reserved.
Panel Protector for EIZO 54 cm (21.3) inch class LCD Monitors
00N0L757A1
(U.M-RP904-AL)
Separator
Tape (blue)
/