Eizo RP-904 User manual

Category
Flat panel accessories
Type
User manual

This manual is also suitable for

Note
•Surfaceofthepanelprotectorcatchesthedirt(dustorngerprints)easily.Pleaseusetheenclosedgloveswhileinstalling
andremovingthepanelprotector.
•PleaseusethesuppliedmaskingtapeandbecarefulnottoscratchtheLCDpanelorthecabinetwiththepanelprotector
duringinstallation.Alsopleasedonotremovethepanelprotectoroften.ItmayscratchorresultindamagetotheLCD
panel.
•WhenusingLCDmonitorwithoptionalpanelprotector,itispreferabletoavoidusingdownwards.Inthiscondition,the
panelprotectormightbecomebendorslipoutfromthemonitor.
•IfusingtheIntegratedFrontSensorafterinstallationofapanelprotector,besuretoexecutecorrelationusingRadiCS/
RadiCSLE.RefertoeachUser’sManualfordetails.
Installation
Before installation, please remove dust and stains from the LCD panel.
1. 2. 3.
Lever
Tape
(2)
(1)
(1)
(2)
Cut (RP-911/RP-913)
Cut (RP-912)
Cut
(RP-904)
1. Stripthetapefromtheseparatorandadhereitoneachedgeofthecabinet(ontherightandleft).
WithRP-904/RP-911/RP-913,adherethetapeonlongsidesofthecabinet;withRP-912,adherethetapeonshortsidesofthecabinet.
2. Setthepanelprotectorintothegroovesofthepanelframe;thelowerrst(1),thentheupper(2).
Thepanelprotectorhasacuttotonthesensor.Alignthecutwiththesensorpositionwheninstallingthepanelprotector.Ifinstalled
inthewrongorientation,thesensormaybedamaged.
3. Withtheenclosedtool(Lever)setthetabsofthepanelprotectorintothesidegrooves(4tabs/6tabs).
PuttheleveronthetabsofthepanelprotectorandmoveittowardtheLCDpaneltoinstall.PositiontheprotectorintotheLCDpanel
tightlywithoutleavinganopening.
4. Stripthetapefromthecabinet.
Removing
Puttheleveronthetabsofpanelprotectorandmoveittowardthecabinettoremove.
Cleaning
Note
•Pleasebesuretokeepthepanelprotectorimmobilizedwhilecleaningit.OtherwiseitmayscratchthesurfaceoftheLCD
panel.Toholdthepanelprotectorbyhand,useglovesorasoftclothtoavoiddustorngerprints.
•Chemicalssuchasalcoholandantisepticsolutionmaycauseglossvariation,tarnishing,andfadingofthecabinetorpanel,
andalsoqualitydeteriorationoftheimage.
•Neveruseanysolventsorchemicals,suchasthinner,benzene,wax,andabrasivecleaner,whichmaydamagethecabinetor
panel.
Thisproductcomeswithaspecialcleaningclothdesignedtoremovestainsfromthepanel.
Ifnecessarystubbornstainscanberemovedbymoisteningpartoftheclothwithwatertoenhanceitscleaningpower.
Tips
•ItisrecommendedtouseEIZOcleaningkit“ScreenCleaner”(option)tocleanthepanel.
Specification
Surface treatment
Anti-Reective Coating (Both sides)
Coating strength
4H
Reectivity
Less than 0.8 %
Light transmission
More than 95.0 %
Dimension/ Weight
RP-904/RP-911: 341.5 mm (W) × 425.7 mm (H) × 1.5 mm (D) / Approx. 290 g
RP-912: 435.6 mm (W) × 328.0 mm (H) × 1.2 mm (D) / Approx. 210 g
RP-913: 329.0 mm (W) × 437.1 mm (H) × 1.2 mm (D) / Approx. 210 g
Accessories
Lever (for Panel Protector), Gloves, Cleaning Cloth, User’s Manual, Masking tape 4 pieces (2 sets)
Copyright© 2012 EIZO NANAO CORPORATION All rights reserved.
Panel Protector for EIZO 54 cm (21.3) inch class LCD Monitors
00N0L757A1
(U.M-RP904-AL)
Separator
Tape (blue)
  • Page 1 1

Eizo RP-904 User manual

Category
Flat panel accessories
Type
User manual
This manual is also suitable for

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI