Metz 40MTB2000Z User manual

I've reviewed the disassembly instructions for the Metz 40MTB2000Z TV. This document outlines the necessary steps for disassembling the device, including removing the rear panel and circuit boards, it also mentions a important safety warning. I am ready to answer your questions about the instructions provided in this document.
What tool is needed for disassembly?

What to do before removing the rear panel?

Are there any safety concerns during disassembly?

Metz Consumer Electronics GmbH

Ohmstrasse 55 - 90513 Zirndorf

Tel. (0911) 9706-0 - [email protected]

Demontageanleitung

Disassembly instructions

Metz 40MTB2000Z

Technische Änderungen und Irrtümer vorbehalten!

Technical changes and errors excepted!

U2199_40300_00

Notwendige Werkzeuge:

Nessesary tools:

Schraubendreher PH2

Screw driver PH2

1 Demontage der Rückwand

a) Schrauben mit einem

Schraubendreher PH2 entfernen.

b) Laschen leicht aufbiegen und

Rückwand gleichzeitig anheben.

1 Disassembly the rear panel

a) Remove screws with a screw driver

PH2.

b) Slightly bend open the tabs and lift

the rear wall at the same time.

2 Demontage der Leiterplatten

Elkos können Restladung

enthalten.

Elkos may contain residual

charges.

Schrauben mit einem Schraubendreher

PH2 entfernen.

2 Disassembly of the printed

circuit boards

Remove screws with a screw driver

PH2.

Vor Entfernen der Rückwand

Netzstecker ziehen.

Pull out the mains plug before

removing the rear panel.

PH2

PH2PH2

PH2