MK700 Instructions www.remotepro.com.au
1. Please open the Forza motor by pushing the
dark red button located on the motor.
2. Inside the motor, you will see a receiver
board, locate the SW1 button and press this
once.
3. Next press one of buttons on the new
remote (any button) twice.
4. Please wait a few seconds and test the new
remote.
5. Put the cover back.
Please note that for unit complexes, the S1
(program) button is usually located in the stand-
alone receiver. This can be found near the motor,
as shown by the picture below.
As the arrow pointing, the SW1 (Learn_1)
button is inside the receiver, then you can
follow the same instructions above.
