Balboa Slimline Press Fit Escutcheon Installation guide

Slimline Press Fit Escutcheon

Installation Instructions

Insert the rubber O’ring #2 into the Slimline wall ﬁtting #1.1.

Place the Slimline eyeball #3 on top of the O’ring #2.2.

Place the poly spacer #4 on top of the eyeball #3. 3.

Center the Slimline escutcheon plate #5 over the face of the Slimline wall ﬁtting #1, and tighten 4.

until snug.

Press metal escutcheon #6 ﬁrmly over plastic escutcheon plate #5. 5.

Caution: Do not use abrasive or caustic cleansers on decorative escutcheons

as they will damage the ﬁnish and void the warranty.

88-4043 Rev A July 1, 2009

Diagram:

Slimline Eyeball

Slimline Wall Fitting

Slimline

Escutcheon

Plate

Slimline

Press Fit

Escutcheon

Poly Spacer

O’ring