2. CPI
  3. Bunch Note Feeder

CPI Bunch Note Feeder User guide

  • I have reviewed the user guide for the Note Feeder. This document provides comprehensive instructions for loading notes, replacing the cartridge and tray, and troubleshooting common feeding issues. I can answer questions about these processes and any other content within this document.
  • What is the maximum number of notes that can be loaded in the tray?
    What should I do if notes stop feeding?
    What should I do after replacing the cartridge?
1
Load notes into
note tray.
30 Notes Maximum
per bundle
2
Ensure notes
are flat in note tray.
3
If notes stop
feeding, remove all
notes, look for and
correct any folded
notes and place
notes neatly back
into tray.
1
Firmly replace
cartridge. The unit
may run briefly. The
yellow lever must
return to the original
position.
2
Replace the note
tray.
**If the bill validator
is still out of service
reset device or cycle
power.
FAULT RECOVERY, cont.
14 © 2008 MEI. All rights reserved. User_guide_27aug08
Bunch Note Feeder User Guide
Bunch Note Feeder User Guide
STEP 3: CARTRIDGE AND TRAY REPLACEMNET LOAD NOTES
FAULT RECOVERY, cont.
1
2
1
Press and hold
yellow lever.
2
Pull cartridge tab
while lever is pressed.
3
Remove cartridge
fully/ by gripping tab.
(Unit may try to reject
any stuck notes after
cartridge removal).
4
Look for stuck
notes and remove.
1
2
Do not power
off device or
safe.
1
Squeeze
yellow handle.
2
Remove tray.
FAULT RECOVERY
23
STEP 1: NOTE TRAY REMOVAL STEP 2: CARTRIDGE REMOVAL
/