English | 11 of 14
Turning the heater on and off:
• Plug the heater in to the wall and flip the on/off switch to turn the heater on. The heater is
now in stand-by mode and the stand-by button and timer button will light up.
• Press the stand-by button. The appliance will emit a ‘beep’, the rest of the buttons will light
up and the appliance is ready for use. When the heater turns on, it will be on its highest
power setting.
• To turn the heater off, press the stand-by button. The heater will return to standby mode
and the control panel screen will turn off.
• Flip the on/off switch to turn the heater off completely.
Adjusting the heat settings:
• Press the mode button to cycle through the power modes of high , medium ,
low , and eco mode.
• In eco mode, the ‘ECO’ display will be lit up and the heater’s power will automatically adjust
to keep the room at the temperature that has been set as the thermostat setting. When the
set temperature has been reached, the heater will turn off. When the room temperature
drops below the set temperature, it will turn back on again.
Adjusting the thermostat settings:
Note:
• If you don’t set the thermostat, in eco mode the default thermostat temperature is 23°.
• If you set the thermostat temperature, the heater will be in eco mode regardless of the
power setting you choose.
• The thermostat temperature setting range is between 10°C and 30°C.
To set the heater’s thermostat, follow the below steps:
• Press the thermostat button. The temperature display will start blinking.
• Use the increase and decrease buttons to set your desired temperature.
• The temperature display will stop blinking and the chosen temperature will appear on
screen. The heater will maintain the temperature in the room by switching on and off
automatically.
Setting the timer:
To set a timer for the heater to automatically turn on, follow the below steps:
• While the heater is in stand-by mode, press the timer button. The display will
• flash ‘0.0’.
• Use the increase and decrease buttons to set a time between 1 and 24 hours. The time will
increase in 0.5 hour increments until it reaches 5 hours, and then it will increase by 1 hour
increments, until it reaches 24 hours.
• The timer button will blink until the time is set. The number of hours remaining will show on
the display.
• The heater will automatically turn on when the heater display reaches ‘0.0’ again.