2. Waterous
  3. SL10 LED

Waterous SL10 LED, 5000042-01, PRESSURE GAUGE Operating instructions

  • Hello! I am an AI chatbot trained to assist you with the Waterous SL10 LED Operating instructions. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
Pressure Gauge Installation Instructions
Subject:
Revision:
Noshok 3 inch Low Pressure Gauge Installation Instructions
10/05/04 Revision Date: Standards No. 5000042-01
Page 1 of 2
Date Originated:
Hole Preparation and Gauge Mounting
1. Prepare or conrm a 3 3/16" diameter hole in panel.
2. Install gauge through front of panel and secure with panel clamp provided. Check to make sure
gauge is level before tightening clamp.
3.188"
[81mm]
Plumbing the Gauge
1. Install 1/4 FNPT x 6mm tube push-in style low pressure tting provided using standard plumbing
practices.
2. Cut appropriate 6mm tubing as squarely as possible and to the required length.
3. Insert tube into tting using a slight twisting motion.
4. Friction will be evident as the tube slides past the internal O-ring.
5. Continue pushing until the tube bottoms rmly against the internal tube stop.
kPa
bar
0
500
1000
2500
2000
1500
0
5
10
15
20
25
6mm OD
tubing
1/4 FNPT x 6mm
tube tting
kPa
bar
-100
-60
-40
05
-0.2
10
15
20
25
-0.4
-0.6
-0.8
-1.0
0500
1000
1500
2000
2500
-20
-80
B 03/15/08
kPa
bar
0
2000
4000
10000
8000
6000
0
20
40
60
80
100
Pressure Gauge Installation Instructions
Subject:
Revision:
Noshok 3 inch High Pressure Gauge Installation Instructions
10/05/04 03/15/08B Revision Date: Standards No. 5000042-02
Page 2 of 2
Date Originated:
Hole Preparation and Gauge Mounting
1. Prepare or conrm a 3 3/16" diameter hole in panel.
2. Install gauge through front of panel and secure with panel clamp provided. Check to make sure
gauge is level before tightening clamp.
3.188"
[81mm]
6mm OD
high pressure tubing
1/4 FNPT x 6mm tube
Plumbing the Gauge
1. Install 1/4 FNPT x 6mm tube compression style high pressure tting provided using standard
plumbing practices.
2. Cut appropriate 6mm high pressure tubing as squarely as possible and to the required length.
3. Insert tube into tting making sure that it rests rmly on the shoulder of the tube tting body.
4. Establish a starting point by tightening the nut until the tubing will not turn by hand or move axially
in the tting. Scribe the nut at the 6 o'clock position.
5. While holding the tting body steady, tighten the nut 1 1/4 turns to the 9 o-clock position.
6. Pull open (pull up) the vent on the top of the gauge to ensure gauge accuracy.
/