YITAHOME SF657S01PL User manual

Brand: YITAHOME

Model: SF657S01PL

Type: User manual

3

Notice:

1. Follow the installation instructions. Please conﬁrm all accessories are present before installation.

2. Do not fully tighten the screws at ﬁrst Fully tighten screws until all pieces are correctly assembled.

3. If you encounter any problems during installation , please contact our customer service.

Any LP-cylinder unrelated to

result in property damage.personal injury.

maintenance instruction thoroughly before installation or servicing this equipment.

26

cc

hooks

Screws Screw

Keep these small items

away from pets and children to prevent choking.

Assembly

to the Side Panels.

Attach the Base Assembly

Attach the Door Handle

The cylinder base

and the heat shield

must be on the

same side

ing

Insert the Battery

(Consumers need to purchase the batteries by themself)

Put the Lava

Rocks in the

Burner.

to balance the table.

Put lava rocks in the burner

Table Lid Hooks Manual Instructions

Step 1: Place the two hooks on the side panel in the direction of the igniter,

as shown in the ﬁgure.

Step 2: Place the Table Lid Assembly in the direction indicated in the ﬁgure.

cc 2

Ensure the ﬁre pit has cooled down before covering the ﬁre pit with a table lid

4 lbs of lava rocks.

s.

cc cc

Ensure the appliance is cooled down_before use.

Turn the coupling nut counter-clockwise until the regulator assembly is detached

Put the protective cap on the LPG cylinder valve and store the LPG cylinder away from

direct sunlight in a well-ventilated area.

operating and maintenance instruction thoroughly before installation or servicing this

All leak tests should be performed outdoors.

DO NOT smoke during leak testing.

Leak test should be performed once a year or after LPG cylinder or any gas

system parts had been replaced.

Mix half part liquid detergent with half part water to make leak check solution.

If there is a leak, disconnect ﬁrst and reconnect, then test again. If bubbles continue to

appear after several attempts, you should replace the hose or cylinder valve.

Contact a qualiﬁed service technician if the attempts of stopping the leak(s) are unsuccessful.

Press and turn control knob to the LOW " "position. Keep pressing the control knob

and press the IGNITOR button " "until the burner is lit.

Once the burner is lit, continue to hold the control knob in the LOW " " position for 20 seconds.

5.Release and turn the control knob counterclockwise to the HIGH " " or the desired ﬂame height.

Wear heat-resistant gloves, put a lit long match or lit long butane lighter near

Press and turn control knob to the LOW" " position.

the

4. Hold the control knob in the LOW" " position for 20 seconds.

prevent clothing ignition & burns.

Thank you for your purchase. To ensure the product works well and lasts longer for your

enjoyment, we therefore provide a general list of care and maintenance tips for you.

Before servicing or cleaning, make sure the ﬁre pit is cooled.

expose to

sheltered

the

is tighten

or Part replacement may be

required

Part replacement may be

required

thermocouple

thermocouple

Part replacement may be

required

Gas line is worn out

the

Burner ports are clogged or

Ensure the gas line is not bent

and the burner is not clogged

Carbon deposit is accumulated

thermocouple thermocouple

Incorrect alignment of oriﬁce

and burner aligned

Page is loading ...

1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21

YITAHOME SF657S01PL User manual

Brand: YITAHOME

Model: SF657S01PL

Type: User manual

Download PDF

Other documents