ESP EMLED5WMBULK User manual

Brand: ESP

Model: EMLED5WMBULK

Type: User manual

ESP EMLED5WMBULK is a 5W LED IP65 MAINTAINED 3HR EMERGENCY BULKHEAD / EXIT SIGN. It is designed to comply with the recommended codes of practice for emergency lighting of premises and should be installed by a competent person in accordance with the relevant wiring regulations.

The luminaire has a rated input supply of AC 240V 50Hz and a rated output power of 28 P CS LED. It has an operating relative humidity of less than 90% and a battery specification of 3.6V 1800mAh 3Cell Ni-Cd, Stick. The battery temperature classification is 55°C continuous ambient temperature and the emergency duration is more than 3 hours. The change over time is less than 1 second.

EMLED5WMBULK

EMLED5WMBULKEX

5W LED IP65 MAINTAINED 3HR

EMERGENCY BULKHEAD / EXIT SIGN

Month Test

Sign Date Sign Date Sign Date Sign Date Sign Date

1 Functional

2 Functional

3 Functional

4 Functional

5 Functional

6 1 hour

7 Functional

8 Functional

9 Functional

10 Functional

11 Functional

12 3 Hour

1st year 2nd Year 3rd Year 4th Year 5th year

T: +44 (0)1527 51 51 50 F: +44 (0)1527 51 51 43

E: sales@espuk.com

Luminaire Type/Ref: Date of Installation: Location:

TEST RECORD SHEET

W: www.espuk.com

www.espuk.com

GENERAL INFORMATION

Our products are designed to comply with the recommended

codes of practice for emergency lighting of

premises and be installed by competent person in accordance with the

relevant wiring regulations.

LUMINAIRE INFORMATION

Rated input supply: AC 240V 50Hz

Rated output power: 28 P CS LED

Operating relative humidity: Less than 90%

Battery Specification : 3.6V 1800mAh 3Cell Ni-Cd, Stick

Battery Temperature Classification: 55°C continuous ambient temperature

Emergency Duration: More than 3 Hours.

Change over time: Less than 1 second.

The Ta rating of this fitting is minimum 0 and maximum 40°

MONITORING

Green indicator lamp (LED) normally continuously ‘on’. Indicator lamp goes

out if A.C. supply or charger fails.

WARNING

• This product must be disconnected from the circuit if subjected to any high voltage or insulation resistance

testing. Irreparable damage will occur if this instruction is not followed

• Recommended routine test procedure in accordance with BS 5266

• Daily check - check that the status GREEN LED indicator is illuminated

• Monthly functional test - simulate a mains supply failure for approx. 30 secs by operation of key switch or

switching off a circuit breaker. Ensure normal supply is restored after test and the indicator status LED

is illuminated

• Twice yearly conduct a one hour duration test - simulate a mains supply failure for one hour continuous test

by operation of key switch or switching off circuit breaker. Ensure normal supply is restored after test and the

indicator status LED is illuminated

• Annual full three hour duration test - conduct a three hour continuous duration test. Simulate a mains supply

failure for three hour continuous test by operation of key switch or switching off circuit breaker.

Ensure normal supply is restored after test and the indicator status LED is illuminated

• If the luminaire fails any of the above tests, please contact a

GENERAL

ould be recycled in the

correct manner when it reaches the end of its life. Check local authorities for where facilities

exist. Clean with a soft dry cloth only, do not use aggressive cleaning products or solvents

WARRANTY

GENERAL INSTRUCTIONS

These instructions should be read carefully and retained after installation by the end user for

future reference and maintenance.

These instructions should be used to aid installation of the following product:

EMLED5

SAFETY

• Installation of this luminaire should only be carried out by a

competent person to the current IEE Wiring Regulations (BS 7671)

• Please isolate mains prior to installation/maintenance

• Check the total load on the circuit (including when this lumina

exceed the rating of the circuit cable, fuse or circuit breaker

• Please note the IP (Ingress of Protection) rating of this luminaire when deciding

the location for installation. This luminaire is suitable for indoor and outdoor use.

• This product is Class II double insulated

• This product is non-dimmable

A deep (150mm) clear diffuser is also available to provide double-sided signage if required.

It makes the product achieve a viewing distance of 28 meters.

• This product is IP65 rated

INSTALLATION

• Provide power to the required point of installation. Suitable IP rated junctions boxes

should be used where required

•

ng not to infringe with

any joists, gas or water pipes or electrical cables

•

feed the mains input through

• Use a suitable IP rated 20mm compression gland

• For non-maintained operation please wire up connector block as shown in Fig 3

• For maintained operation (luminaire always on) please see Fig 4

• For switchable maintained operation see Fig 5

• Connect the battery via the plug and

socket on the PCB

• Switch on the power supply and ensure

the LED indicator is illuminated Green

• Remove two screws

to remove diffuser

• Pull apart tabs (see Fig 2) to

gain access to the connections

Fig 1 Fig 2

Fig 3

Fig 4

Fig 5

Insert link

cable

Remove screws Pull apart tabs

Please contact your supplier.

d=30

EMERGENCY FUNCTION

• Battery Specification - Ni-Cd 3.6V 1800mAh

• A second / permanent live (marked ‘L’) should be provided to the fitting.

This will allow the fitting to sense when there is a mains power failure and activate emergency mode.

The light will operate at a reduced output in emergency mode.

• Failure to provide a permanent live will cause the batteries to power the fitting when it is switched off.

This is not recommended as it will reduce the lifetime of the batteries.

• Following a full discharge, a 16 hour charge will be necessary to fully re-charge the batteries.

• On first operation a 24 hour charge will be required to fully charge the batteries.

• The battery is charging when the green charge indicator LED is illuminated. This LED should remain lit

after the fitting is switched off.

• It is advised that routine testing of emergency luminaires is undertaken and logged in order to ensure

that they are operating correctly.

Should luminaire fail to deliver a full 3hr emergency duration/illumination, a replacement battery

should be sought of the same specification. Please contact ESP for replacement battery option

with luminaire model number and batch code.

Photometrics files available from ESP Technical Support Team on request

electrician. See overleaf for test record sheet

ESP EMLED5WMBULK User manual

ESP EMLED5WMBULK User manual

ESP EMLED5WMBULK User manual

Related papers

Other documents