Antennas Direct DB8 Assembly Manual

  • Hello! I am an AI chatbot trained to assist you with the Antennas Direct DB8 Assembly Manual. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
DB8 Antenna Assembly
1. The DB8 comes with:
• 2reectors
• 2setsofbowtieelements
• Combinerbarswith75ohmtransformer
• 4setsofboltswithaluminumsleeves
• 2crossbraces
• 2Mastclamps
1.
2. Attachcombiningbarstothebindingposts
ontheantenna(bowtie)elements.Tighten
usingsuppliedwingnuts.Thiselectrically
joinsbothhalvesoftheantenna.
2.
3. Left,bothsetsofelementsjoinedwiththe
combinerbars.Thetransformerisinthecenter.
3.
4. Next,attachthecrossbracestotherearofthe
reectorasshownusingsuppliedbolts.
4.
877-825-5572
1699WestFifthStreet
Eureka,MO63025
www.antennasdirect.com
5. Note:adjustableUboltmastclampsfacetherear
5.
6. Attachthereectorstotheelementsusingthe
suppliedboltsandspacers.Slidethespacersover
theboltssothefrontandbackhalvesareseparated
by3.
6.
Helpful Tips:
• Ifyourcablerunisgreaterthan75’,Apre-ampliermayberequired.
• UHFsignalsarelineofsight.Getasmuchelevationaspractical.
• AtticInstallationswillcut40%-50%ofyoursignalstrength.
• KEEP ANTENNA AWAY FROM POWER LINES
7. Assembly Complete
7.
/