ANSMANN 5111173 Datasheet

Page is loading ...



OPERATING INSTRUCTIONS MP3 SMART

Please read the operating instructions before use!

USE OF THE CHARGER

Plug-in charger for 1-2 NiCd/NiMH å NiCD as well as NIMH can be charged at

the same time • Charging indicators for cylindrical cells • Reverse connect

protection

ATTENTION

Use only with NiCd or NiMH cells. Non rechargeable batteries or other types

(Alkaline etc.) could cause an explosion!

DISPLAY FOR CYLINDRICAL CELLS :

Green LED constant: Charging

SAFETY INSTRUCTIONS

•Please read the operating instructions carefully before using the charger •Keep

the charger in a dry place •

In order to avoid the risk of fire and/or electric shock,

the charger must be protected against high humidity and water •Do not plug in

the charger if there are any signs of damage to the housing, cables, mains adaptor

or DC connector. In case of defect, please return to an authorised service centre

•Keep out of reach of children •Do not operate the device without adult

supervision •Do not attempt to open the charger •Disconnect the device from the

mains supply after use •To clean the charger, disconnect it from the power adaptor

and use a dry cloth only •If the safety instructions are not followed, this may lead

to damage to the charger or batteries or even serious injury to the user.

OPERATION

Plug in the charger to the mains. The charger starts automatically when one or

more cells are inserted into the charging slots. Always connect the cells in the

right direction for polarity (according to the symbols in the charging slots). The

cells do not have to be inserted simultaneously as the charging processes are

separate from each other.

THE MAXIMUM CHARGING TIME FOR EMPTY CELLS CAN BE CALCULATED

WITH FOLLOWING FORMULA:

Charging time (h) =

1.4 (charging factor) x capacity (mAh)

charge current (mA)

Rechargeable batteries are not to be disposed of in domestic waste. Return used

batteries to your dealer or to a battery recycling collection point.

MAINTENANCE AND CLEANING

To ensure correct functioning of the charger, keep the contacts of the base

station and the adaptor units free from dust and dirt. Do not attempt to open the

charger. Repairs should only be carried out by authorised service centres.

Page is loading ...

ANSMANN ENERGY GMBH

Industriestr. 10 •D-97959 Assamstadt •Germany

e-Mail: hotline@ansmann-energy.com

www.ansmann-energy.com

ANSMANN 5111173 Datasheet

ANSMANN 5111173 Datasheet

in other languages

Related papers

Other documents