- 9 -
Starting the automatic pet feeder timer
for tomorrow:
Instead of pressing the START NOW but-
ton , press the START TOM button .
If you have recorded a voice message,
this will be played once. The bowl with
the food chambers now turns to the
start position. The bell symbol and Zz
are now shown in the display .
Replacing the batteries of the automatic
pet feeder
If the battery status display LO BATT
lights up, the inserted batteries are low
on charge. Always replace all four
batteries with new type C/baby/1.5 V
batteries. To do this, follow steps 2 to 5
in the section "Operation".
Note: Do not dispose of batteries in house-
hold waste! Drop off used batteries at a
collection or disposal site. Used
batteries can also be returned to the
shop where they were purchased.
Cleaning
Clean the automatic pet feeder and its
components regularly. For daily use, we
recommend a cleaning at least once per
week.
For cleaning:
➩ Set the main switch on the
bottom side of the automatic pet
feeder to OFF.
➩Loosen the lid on the top side of
the automatic pet feeder. Do not apply
force when doing so, otherwise it
may be damaged. Then remove the
lid from the automatic pet feeder.
➩Remove the cover with water dish
from the automatic pet feeder.
➩ Remove the cover flap for the food
chambers .
➩Lastly, remove the bowl with the
four food chambers from the
casing .
➩To clean the casing, use only a damp
cloth and a mild cleanser. Then
carefully dry the casing.
Danger! Never hold the casing under
flowing water or immerse it in water!
Otherwise the automatic pet feeder may
be irreparably damaged. There is also
the risk of an electric shock!
➩ The lid , cover , cover flap and
bowl can all be cleaned with hot
water and cleanser. Be sure to rinse
the parts thoroughly to remove any
cleaning product residue.
➩ Dry the lid , cover , cover flap
and bowl carefully. Then place
them back into the casing in their
original positions.
➩ Set the main switch on the
bottom side of the automatic pet
feeder back to ON.
KH 6900