sks SHOCKBLADE 29 ZOLL 27.5 User manual

sks
Brand
sks
Model
SHOCKBLADE 29 ZOLL 27.5
Type
User manual
GERMANY
1a 1b 3a 3b
2a
2b
5a 5b 5c
4
6
A
6
3
2
1
3
5
4
B
D
C
Parts
Large expansion sleeve
29-39 mm
Small expansion sleeve
19-29 mm
Large cone Small cone
Large rubber ring
Small rubber ring
Short adapter
35 mm
Medium adapter
41 mm
Long adapter
47 mm
NOTE!
Insert the cone as far
as possible into the
steerer tube.
MANUAL ¬ SHOCKBLADE 29" 27.5plus ¬ 11097 MOUNTAIN
GERMANY
1.
1.
2.
2.
E
Fslide-off
slide-on
EN . KONUS 2.0 monuting system
The SKS clip-on mudguard is a lightweight mudguard with maximum splash protection in any weather.
Please observe the mounting instructions to ensure optimal performance.
Fitting the mounting system:
The inside of the steerer tube must be free of grease and clean for tting the mounting system.
If necessary, clean the steerer tube.
1. Select the largest possible expansion sleeve 1a or 1b that ts into the steerer tube. Position the appropriate rubber ring in the
centre notch of the expansion sleeve as shown in Figure B. Select the appropriate pair of cones 3a or 3b .
2. Mount the adapter with the pair of expansion cones and secure it with the screw 4 and nut 6 (Figure B).
The short adapter 5a is used for mounting on narrow fork bridges, while the adapter 5b and 5c are intended for wider ones.
The length of the adapter should be approximately the width of the fork bridge.
3. Tighten the screw 4 so that the mounting system can still be pushed into the steerer tube with slight pressure.
4. Insert the unit into the steerer tube (Figure C) and align the adapter parallel to the track, making sure that the arrow
on the adapter 5 points is in the direction of travel (Figure D).
5. Now tighten the screw 4. A „snapping sound“ is normal.
Fitting the SKS clip-on mudguard (Figure E):
From the front, slide the clip-on mudguard onto the adapter track from the front until it clicks into place,
keeping the quick-release button depressed.
Removing the clip-on mudguard (Figure F):
To remove it, press the quick-release button and pull the mudguard off towards the front.
The mounting system remains rmly xed on the headset.
SAFETY INFORMATION:
Regularly check that the adapter is securely mounted. Make sure that when fully deected, there is adequate clearance between
the mudguard and the tyres or between the mudguard and the fork bridge/booster.
MANUAL ¬ SHOCKBLADE 29" 27.5plus ¬ 11097 MOUNTAIN
EN
  • Page 1 1
  • Page 2 2

sks SHOCKBLADE 29 ZOLL 27.5 User manual

sks
Brand
sks
Model
SHOCKBLADE 29 ZOLL 27.5
Type
User manual
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents