16 English
Important information on
operation and traffic safety
Making settings to and operating the Porsche
Rear Seat Entertainment during driving can
distract you from the traffic. You may lose control
of the vehicle.
f The PRSE may only be operated by
passengers sitting in the rear of the vehicles
during driving.
Unqualified tampering with the electronics and the
associated software may lead to malfunctions.
Malfunctions to the electronics may impair the
operational safety of the vehicle, possibly
endangering the passengers.
f Do not tamper with the electronics or the
associated software of the PRSE. Unqualified
tampering with the electronics and the relevant
software may lead to malfunctions.
f Have faults remedied immediately.
Contact a qualified specialist workshop.
We recommend a Porsche partner for this
work as they have trained workshop personnel
and the necessary parts and tools.
Risk of damage to external devices connected to
the inputs of the PRSE. These devices have not
been tested for compatibility with the vehicle
electrical systems of the vehicle by Porsche.
There is therefore a risk of interference from such
devices.
Porsche will not assume any liability for damage
caused by third party devices.
f Do not connect any external devices to the
inputs of the PRSE.
General information
Ensure that your PRSE and the headphones do not
come into contact with water or other fluids.
In the event of extreme temperature fluctuations,
condensation may form. In this case, leave the
PRSE switched on after removing a CD/DVD to
allow the condensation to evaporate inside the
device.
Never insert foreign objects into the CD/DVD slot.
Only insert intact and undamaged CDs/DVDs into
the device.
Poor road conditions and vibration may cause
interruptions during the playback of files.
Power supply
The PRSE is supplied with power via the vehicle
battery. The power remains connected even when
the engine is switched off and the vehicle is
locked. The vehicle energy management system
determines when the PRSE is switched off
automatically after the engine is stopped,
depending on the battery charge.
This delay may be up to 30 minutes.
Notes on USB
No USB devices which require the installation of
special drivers may be connected to the USB port
of the PRSE.
The use of USB hubs is not permitted.
Owing to the rapid development of USB media,
compatibility with storage devices and MP3
players cannot be guaranteed.
It may not be possible to operate USB devices
with high power requirements (e.g. external hard
drives) via the USB port.
f Do not leave USB devices in the vehicle for
extended periods because extreme ambient
conditions (temperature fluctuations, humidity)
can occur.
Operation of the PRSE
during driving.
T
ampering with the
electronics of the PRSE.
WARNING
h
CAUTION
h
NOTICE