MCD 700
MCD 702
Quick start guide
What’s in the Box?
You should find these items upon opening the box.
2
User Manual
1
Quick Start Guide
Composite Video Cable FM and AM antenna Remote Control
Quick Start Guide
User Manual
Control Cable
MCD700 QUG_Eng-37 2005.7.7, 14:151
AC power cord
Speaker
(Right)
Speaker
(Left)
FM antenna
AM antenna
1
5
4
3
1
Speaker connection for MCD702
2
Connect the speakers to the SPEAKERS (8ohm) terminals with two speaker cables. Right speaker to "R" and
left speaker to "L", red wire to "+" and silver wire to "–".
Connect the supplied AM antenna and FM antenna to the respective terminals. Adjust the position of the
antenna for optimal reception.
Connect the serial port marked CONTROL CABLE at the rear of the DVD player to the same port at the
rear of the power amplifier with the supplied control cable.
Connect the VIDEO OUTPUT jack at the rear of the DVD player to the video input jack on the TV using the
supplied video cable (yellow).
Connect the power cord of the DVD system to the AC power outlet.
1
2
3
Tip
See the User Manual for other TV connection options.
4
5
MCD700 QUG_Eng-37 2005.7.7, 14:152
Setting up the TV
Press STANDBY ONB on the front panel of the DVD player or B on the remote to switch the DVD system
on and then select the disc source.
Switch on the TV set and set to the correct video-in channel until the blue Philips DVD background screen
appears on the TV.
2
1
2
1
Tip
See your TV manual for more details.
3
Setting language preferences
Press SYSTEM on the remote to enter the system menu.
Press 1 2 on the remote to enter the 'Preference Page'. Then, select the preferred
audio, subtitle and disc menu languages using 1 2 3 4 and OK on the remote.
Press 1 2 on the remote to enter the 'General Setup Page' and select the
preferred OSD language using 1 2 3 4 and OK on the remote.
IR SENSOR
MCD700
DVD/RECEIVER/POWER AMPLIFIER
STANDBY-ON
STANDBY-ON
Tip
You can enter the 'Preference Page' in full stop mode only.
MCD700 QUG_Eng-37 2005.7.7, 14:153
Loading a disc
Select the disc source, then press OPEN•CLOSE at the top of the DVD player or 0 on the remote.
Load in a DVD disc with the label side facing up.
A disc menu pops up.
Playback
Use 1 2 3 4 and OK or Numeric Keypad (0-9) on the remote to select a playback feature or item.
Press PRESET/ÉÅ (orÉÅ on the remote) to start playback.
Types of Discs used
on this DVD System
2
1
3
Tip
Refer to the User Manual for playback of other types of discs.
2
1
Type
DVD VIDEO
AUDIO CD
VIDEO CD
MP3-CD
WMA
Record Playback Edit
DVD+RW
Super VCD
VIDEO CD
2005 © Koninklijie Philips Electronics N.V.
All rights reserved.
www.philips.com
MCD700 QUG_Eng-37 2005.7.7, 14:154
-
1
-
2
-
3
-
4
Philips MCD 702 User manual
- Category
- DVD players
- Type
- User manual
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
-
Philips MCL701 Specification
-
Philips MCD700/79 User manual
-
-
-
Philips MCD700 User manual
-
-
-
-
Philips MCD510/21M User manual
-