1
DT-E3
Conversion Cable (16-Pin to 15-Pin) with Bracket
DT-E3
User’s Guide
CONTEC CO.,LTD.
Thank you for purchasing the DT-E3.
This product is one-to-one connnector cable with bracket. The 15pin Flat cable connects the 16pin post
head connector to the 15pin D-SUB connnector.
External Dimensions
150
+5
-0
mm
B01
B02
B08
A01
A02
A08
CN2
Connector used (board side) :
16-pin post head connector
[F(female)type]
PS-16SEN-D4P1-1C[JAE]
or equivalent
9
10
15
1
2
8
CN1
Connector used (bracket side) :
15-pin D-SUB connector
[F(female)type]
17JE-13150-02(D1)A[DDK]
or equivalent
Specifications
Item Specification
Connector used
(board side)
16-pin post head connector [F(female)type] PS-16SEN-D4P1-1C[JAE] or equivalent
Connector used
(bracket side)
15-pin D-SUB connector [F(female)type] 17JE-13150-02(D1)A[DDK] or equivalent
Screw nut:
UNC#4-40(
Inch screw
)
Cable Flat cable Conductor size: AWG28 Conductor composition: 7pcs/0.127mm UL2651
Weight 50g
Notes!
- Do not strike or bend the product. Otherwise, the product may malfunction, overheat, cause a
failure or breakage.
- Do not insert or remove the connector while the power is turned on to the PC. Failure to observe
this precaution may cause malfunction, overheating.
- The specifications of this product are subject to change without notice for quality improvement.
Even when using the product continuously, be sure to read the manual and understand the contents.
- Regardless of the foregoing statement, CONTEC assumes no responsibility for any errors that may
appear in this document or for any results of using the product.
- All relevant issues have been considered in the preparation of this document. Should you notice an
omission or any questionable item in this document, please feel free to notify CONTEC CO., LTD.
