Parts List
DESCRIPTIONPART NUMBERQTYITEM
HEX TAP BOLTM14 - 1.5 x 40 HEX41
LOCK WASHER9/1642
HEX TAP BOLT
M12-1.25 x 35mm23
CONICAL TOOTHED WASHER1/2"24
GROSS LOAD CAPACITY WHEN USED AS A WEIGHT CARRYING HITCH: LBS. TRAILER WEIGHT & LBS. TONGUE WEIGHT.
GROSS LOAD CAPACITY WHEN USED AS A WEIGHT DISTRIBUTION HITCH: LBS. TRAILER WEIGHT & LBS. TONGUE WEIGHT
***DO NOT EXCEED VEHICLE MANUFACTURER'S RECOMMENDED TOWING CAPACITY.***
HAVING INSTALLATION QUESTIONS? CALL TECHNICAL SUPPORT AT
1-800-798-0813
INSTALLATION STEPS
PERIODICALLY CHECK THIS RECEIVER HITCH TO ENSURE THAT ALL FASTENERS
ARE TIGHT AND THAT ALL STRUCTURAL COMPONENTS ARE SOUND.
Curt Manufacturing Inc., warrants this product to be free of defects in material and/or workmanship at the time of retail purchase by the original purchaser. If the product is found to be defective,
Curt Manufacturing Inc., may repair or replace the product, at their option, when the product is returned, prepaid, with proof of purchase. Alteration to, misuse of, or improper installation of
this product voids the warranty. Curt Manufacturing Inc.'s liability is limited to repair or replacement of products found to be defective, and specifically excludes liability for incidental or
consequential loss or damage.
4,000 400
6,000
600
NISSAN XTERRA
7/11/2012
13514
60
30
30
HITCH WEIGHT: LBS.
INSTALL TIME
PROFESSIONAL: MINUTES
NOVICE (DIY): MINUTES
INSTALL NOTES:
78204 / RRH13514
1) Lower spare tire for ease of installation. (Replace later)
2) Lower exhaust by removing (3) bolts from exhaust hanger bracket as shown. (Re-use later)
3) Remove the lower (2) bumper bracket bolts on both side of vehicle as shown. (Discard)
(NOTE: DO NOT REMOVE TOP BOLT)
4) Raise hitch into position over exhaust and secure with M12 hex bolts and conical washers, finger tighten.
5) Install remaining M14 hex bolts and lock washers through hitch and bumper bracket as shown.
6) Reinstall exhaust hanger bracket removed in step 2.
7) Torque all M12 fasteners to 86 lb-ft and all M14 fasteners to 136 lb-ft.
8) Reinstall spare tire lowered in step 1.
- NO DRILLING REQUIRED
- LOWER SPARE
- LOWER EXHAUST
DO NOT
REMOVE
4
3
2
1
2
1
TOOLS REQUIRED
1/2" RATCHET
TORQUE WRENCH
6" EXTENSION
22mm SOCKET
19mm SOCKET
12mm SOCKET
12mm WRENCH
-
1
