2
G Operating instruction
Thank you for choosing a Hama product.
Take your time and read the following instructions and
information completely. Please keep these instructions in a
safe place for future reference. If you sell the device, please
pass these operating instructions on to the new owner.
1. Explanation of Warning Symbols and Notes
Warning
This symbol is used to indicate safety instructions or to
draw your attention to specic hazards and risks.
Note
This symbol is used to indicate additional information or
important notes.
2. Package Contents
• LED Clamp Lamp
• Power supply unit
• These operating instructions
3. Safety Notes
• Protect the product from dirt, moisture and overheating,
and only use it in a dry environment.
• This product is not intended for use by persons, including
children, with limited physical, sensory or mental abilities
or lacking in experience or knowledge, unless they are
supervised by a person responsible for their safety or
have been instructed on how to use the product.
• The product may only be operated with the type of power
supply network described on the name plate.
• Connect the product only to a socket that has been
approved for the device. The electrical socket must
always be easily accessible.
• Disconnect the product from the network when the
product will not be used for a extended time.
• Do not use the product if the power supply unit or the
cable is damaged.
• Ensure that no electrical cables are crushed or damaged
during installation or adjusting.
• Do not drop the product and do not expose it to any
major shocks.
• Do not attempt to service or repair the product yourself.
Leave any and all service work to qualied experts.
• Do not open the device or continue to operate it if it
becomes damaged.
• Do not continue to operate the device if it becomes
visibly damaged.
Warning
Never look straight into the light source and
do not aim its beam of light straight into the
eyes of other people or animals. This could
damage your/their eyes.
• Please note that lights (even LEDs) can generate heat
and may become hot. Always let the light cool off for a
few minutes before touching it or changing it.
• Do not place objects on or hang objects (e.g. decorative
material) on the LED desk lamp. Doing so could create a
re hazard.
• Only use the device with the included LED ballast unit
(power supply unit). Normal power supply units are not
suitable for the lamp.
4. Getting Started and Operation
Connect the supplied power supply unit to the desk lamp.
Secure the lamp on a stable, even, horizontal tabletop and
adjust to your liking. Connect the power supply unit to an
easily accessible outlet.
Touch the on/off button (1) to switch the lamp on and off.
Press the on/off button (1) again to increase brightness in
increments.
5. Care and Maintenance
•Only clean this product with a slightly damp, lint-free
cloth and do not use aggressive cleaning agents.
•Make sure that water does not get into the product.
6. Warranty Disclaimer
Hama GmbH & Co. KG assumes no liability and provides no
warranty for damage resulting from improper installation/
mounting, improper use of the product or from failure to
observe the operating instructions and/or safety notes.
7. Service and Support
Please contact Hama Product Consulting if you have any
questions about this product.
Hotline: +49 9091 502-115 (German/English)
Further support information can be found here:
www.hama.com